2014 Chevrolet Silverado 1500 - Page 7 - Answered Questions & Fixed issues

Take the lens off of the light and change the bulb, it is probably burnt out.

You have a broken brake line somewhere on the truck. and if not a broken line then you need to bleed the whole brake system. Hope this helps.

If after checking the bulbs are ok then the fuses could be suspect!

it is not good practice to hit the gas pedal when you have no oil pressure not only is it wise , you have no idea what is wrong or if in that few seconds , the bearings are running dry what I am thinking that if this started after you have had a service done , that he oil filter is el cheapo type that does not have an anti drain back valve built into the filter when it stands the oil drains out of the filter and also drains the oil galleys so that it takes time to fill the filter and the galleys the filter could be blocked and being bypassed as well check and replace with a reputable make and check that it has an anti drain back valve

hey these silverados are common with speedometer troubles. best thing i recommend is take out cluster and send it out to a speedo repair place online or call ur local salvage yard an try to purchase a used one. good luck

if the sun shell is broken no revers and no 2 gear

the c0281 code on a gm truck is the abs ECBM has lost the voltage to it when the brake pedal is not depressed. so if you are going at a speed above 10-15MPH and the ECBM looses the 12 volts to it ,when the brake pedal is NOT depressed ,, then this code gets generated. the brake switch has a 12 volt feed to the abs switch contact connector. the other side of this switch goes to the other connector pin. these switches wear out get dirty with time. replacing the switch or if your up to it take the switch apart and clean the contacts with a fine abrasive material to remove the oxidation. if pitted or worn replace the switch. one wire is brown the other is purple. working the brake pedal watching the volts is easy way to see if the voltage is steady when you wiggle the brake pedal.. driving on a rough road with a bad switch usually gets it acting up.

rear seal cheap and easy fix --but pull yoke and look and check for cracks this link shows how WTF Trucks How to replace the rear transmission seal on 1997 Chevy 1500

I'm not positive but, I think it's in the driver kick panel area

images for Silverado 1500 remove center console

Valve r hitting

No starter relay on this one. Start signal goes to neutral safety switch on transmission and then directly to starter

I doubt it. A mechanic would check output from the speed sensor, it could be something inside the transmission.

go up from underneath with a long blades screw driver and trip the hood lock. Cable broken in drivers compartment? if enough cable grab it with vise grips.

can mean a whole lotta things; transmission problem there get it checked out.

auto trans or manual trans??

okay so what is the question??

https://www.youtube.com/watch?v=ZivIypAjgvk

check your fuses, if okay may be bad gauge cluster or speed sensor(s)

if the vehicle is 12 years old or less it will be replaced under warranty by GM as it is a recall for faulty ignition switches. other than that there is a good explanation in the workshop manual