20 Most Recent
2002 Dodge Ram Pickup 1500 - Page 9 Questions & Answers
Bought a used 2004, 1500
P0700 is an information code that tell there is a fault code stored in the trans control module which in your case is P0888. if the cause of the DTC P0888 is corrected then the MIL lamp should go out. PO888 is the code for transmission relay, it supplies power to the transmission computer, I would replace the TCM relay, clear the codes and test drive. I would consider diagnostic on the ABS light to see what codes there are pertaining to the ABS, it could be a wheel speed sensor, relay, ABS unit, or the computer.
My dodge 1500 got a
check the crankshaft position sensor down on the transmission on the passenger side up top in the bell housing.
If the crankshaft position sensor is bad it will not start no spark.
I have tow codes on
po132 is bank 1 sensor 1 02sensor shorted to voltage....check your wiring may have a short or a bad sensor. look for any wiring that is rubbed thru or maybe layed on exhaust and melted.
p1389 is no asd output voltage at pcm. truck should not run with this code current. I would clear this code and see if it comes back someone may have pulled relay while running and caused code to set and it remained in history. possible causes would be wiring issue relay itself or pcm
I am trying to locate
the speed output sensor should be locate at the rear of the trans, just forward of the output shaft, on the drivers side. it is semi-round with a 2 wire plug. hope this helps.
2003 Dodge Ram OBD Codes-
Hi,
3335, 3336 - Pressure Feedback EGR(PFE) sensor or EGR Pressure Transducer(EPT) - signal voltage higher or lower than expected.
It indicates the Pressure Feedback EGR (PFE) / Differential Pressure Feedback EGR (DPFE) sensor is out of Self-Test range.
Possible causes:
- Damaged PFE/DPFE sensor.
- Obstructed pressure inlet hose(s).
- Garage exhaust ventilation system affecting PFE/DPFE sensor operation.
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
I recently had the gov
Can you check the pressure on the drivetrain,if the pressure is not good,take off the oil pan and check the filter and the condition of the oil look for pieces on the bottom of the oil pan,if you have ,you got warn pieces inside.
I have a 2004 dodge
That sounds like either they left a wire connector loose and forgot to re-connect it, or they painted a ground surface and now that circuit has no ground to it. I would take the vehicle back to them if the vehicle did not have that problem before it went to them.
Sometimes when i get gas
It sounds as though you are having issues with the float sticking.When you shut it of and restart it you float probably becomes un stuck and it begins to give a reading.
Seems truck has a mind
if it runs fine, I would check for bad motor mounts. if cross member is at mounts, and it is twisted bad enough it may be at fault.
Not finding what you are looking for?