20 Most Recent
2007 GMC Yukon XL - Page 8 Questions & Answers
Replace left front wheel bearing on 2002 yukon 4x4 abs
Remove the axle nut. Put a punch in the fins of the rotor to keep the hub from spinning.
Remove the caliper and the rotor.
Unplu the abs harness.
Remove the three bolts that hold the hub to the knuckle.
Remove the hub/bearing from the knuckle.
Reverse to install. Make sure you torque the three bolts that hold the bearing to the knuckle and the axle nut to the correct torques spec. Failure to do so will cause premature bearing failure.
Also use a good quality bearing. SKF is a good brand.
Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com! I’m happy to assist further over the phone at
https://www.6ya.com/expert/jeremy_d728a59f986299fa
Air or heat only blows
The reason it only blows on high is the blower resister bad..As far as the a/c when it blows hot is the compressor still lock in..If not it could be a bad connection to the compresser or a bad a/c clutch
My 03 Yukon xl Instrement
Hi
Sounds as though u have experience the GM usual cluster failure.Check
for bad connections in the fuse box. Use a test light to verify voltage at all
of the fuse holders.Also check for bad solder point on the board behind the
display.Seems you need to replace the entire instrument cluster.
Please get back to us if you have further query else please accept
this particular suggestion.
Thanks for contacting fixya.com
2001 yukon xl, rear axle
Needs rear axle seals which requires removal of the rear axles. Shafts must be inspected to make sure the surface the seal rides on does not have wear.
I have a 2001 GMC
There is a service bulliten on this and you will need to check on the ground for the ecbm or body control module. Here is the meat and potatyoes of the bulliten.
2000-2006 GMC Yukon, Yukon Denali, Yukon XL
DO NOT REPLACE THE BRAKE MODULE.
Perform the following steps to improve the connection of the EBCM Ground:
Remove the EBCM Ground. The EBCM Ground is located on the frame beneath the driver's side door. If multiple grounds are found in this location, the EBCM ground can be identified as the heavy (12-gauge) wire.
Clean the area, front and back, using a Whiz Wheel®.
Install the ground, then the washer and then the bolt to the frame.
Important: It is important to use the bolts, washers and nuts specified in this bulletin. These parts have been identified due to their conductive finish.
Install a washer and nut to the back side of the frame.
Tighten
Tighten the nut to 9 N·m (79 lb in).
Cover the front and back side of the repair area using Rubberized Undercoating.
An additional check can be made to ensure a good connection for the Battery Cable to Frame ground. It is possible for this ground to cause similar symptoms with the ABS as described above.
Not finding what you are looking for?