Top 20 2003 Hyundai Elantra Questions & Answers

Here is the fuse box diagram, but the Elantra appears to have a rather funky battery fuse! Most vehicles have a main battery fuse but it is on the battery connector wire. If you put in a new ECM, was it programmed to the vehicle? https://www.autozone.com/batteries-starting-and-charging/battery-fuse/hyundai/elantra-gt

Hyundai Elantra (XD; 2000-2006) fuses and relays

Fuse Box Diagrams https://fuse-box.info > hyundai > hyundai-elantra-xd-... The fuse box is located on the driver's side of the instrument panel behind the cover. The location of the fuses in the passenger compartment: Hyundai Elantra ( ...

Check the power to the cluster with your multimeter. You may find a broken wire within the loom.

No, the way to get in is to call a locksmith. They slip an air bag between the door and frame to open the edge a half inch and then insert a bendy rod to pop the lock. It takes 5 minutes. Or you can buy them from Home Depot and it will take you 30 minutes.

You have a short to ground. It is normally wiring in the harness that is subbed through somewhere on it journey to the items covered by the fuses. For all those, I would check behind the fuse box. Are you sure it is covering all those? And the fuse box diagram agrees that is multiple fuses :>)

Hyundai Elantra (XD; 2000-2006) fuses and relays

https://fuse-box.info > hyundai > hyundai-elantra-xd-2... Instrument panel - Here you will find fuse box diagrams of Hyundai Elantra 2004, 2005 and 2006, get information about the location of the fuse panels inside ...

Remove one of the spark plugs and check to see if it is getting spark. If it is not getting spark then you have a ignition problem.

inspect the threads, one might be crushed. try pulling up while turning so the threads engage

bad door locking switch

Replace the starter motor. I don't think you can purchase the Bendix unit separately.

seems like it's going into limp mode intermittently i would try cleaning crack shaft sensor. or replace.

if this has anti-lock brakes it may be the HCU(hydraulic control unit) may have air in it. it may have to be activated to get all the air out.

Sounds like flasher has failed it will be in close proximity to the under-dash fuse panel. Get a new one ,it will help you identify the one your looking for.

run the fault codes and check for crank shaft / cam shaft sensors check that the cam shafts are turning ( broken timing belt /chain) check immobiliser operation

the only fix is to replace the seal anything else is a waste of money and oil

I sent to an auto parts place and bought it and casually asked the clerk where it went. He almost offered to go out into the parking lot to help me. He told me where it went, but then I forgot. They ran out of manuals (handy and cheap), but I got one on order. PS: Kia used the same one and it costs either the same or less. Back then there really wasn't much difference between Kias and Hyundais. You could call up one of the nationally known auto parts suppliers and simply ask the guy over the phone and tell him you'll come down and pick it up if he has one.

Question edited for clarity, correct spelling of model. Question moved to model category. It could be so many things. Find a local auto-electrician, a professional grade scan tool computer will diagnose all the electronics computers, modules and sensors in 30 minutes. https://www.google.com/search?q=auto+electrician+near+me ..

This usually indicates a problem with the transmission control module (TCM). You should have a qualified mechanic inspect and diagnose the problem, as it could be something as minor as a faulty TCM or something more serious such as a transmission failure. Replacement of the TCM or other components may be necessary to fix the issue.

a car.all cars made have service manual. every one.and all that is covered even a 3 inch think book.why not buy one from maker.or tell what country you are in .cars are not the same at all , in all countriessome have 5 or more engines choices and transmissions.check out Europe to learn that.nor did you say what is to be worked on, to torque.buy the book or if in USA read it here, at mitchell1 DIY onlinehttps://eautorepair.net/Marketing/Default.aspbuy the book at the dealerpay on line or google all week long.

buy the shop manual and read. or online at mitchill1 diy, do com, pay $20 like we all do, what is this, no one problem stated , did you mean the truck hatch springs failed, what? install trunk torsion

some cars the dash has autodimmer a sun sensor on the dash some can be disabled , so read the users guide to do that. most cars, we can disable the out dim in the free users guide, search word DIM. bingo,? see on,off ,up ,down or auto?> find the top of dash sun sensor shine a very bright light there, and dash DIM goes full bright, if yes, bingo see the users guide in the glove box yet page 5-42 is your answer see the words obstructs either sensor bingo it is in your manual this. https://www.carmanualsonline.info/hyundai-elantra-2022-owners-manual/?srch=dim

Question edited for clarity to get rid of all the abbreviations. The code P2626 won't go unless you do some corrective work to the Heated Oxygen Sensor and associated wiring. https://www.google.com/search?q=2007+Hyundai+Elantra+GLS+code+P2626 videos as well https://www.google.com/search?q=2007+Hyundai+Elantra+GLS+code+P2626 ..