20 Most Recent
Questions & Answers
Where is the turn signal flasher relay located in a qx4 2001
The flasher is located behind and above the left side of the small fuse box at the driver's left knee. You will need a small rachet handle, 10mm socket and a Phillips head screwdriver. A socket extension of 6 to 10 inches will be helpful. To access the old flasher: 1) Remove bolt securing driver's plastic kick plate and wiggle it out of place and set aside. This is the trim panel just fore of the driver's door opening. 2) Remove two Phillips Head screws on the plastic knee panel. This panel runs below the steering column from left kick plate to the center console. The panel includes the small fuse box access door and two sets of wiring. No need to totally remove this panel; just remove the screws, pull it loose and swing or tie to the right so that you can... 3) Remove the three bolts that secure the fuse panel. Note that the fuse panel "hangs" by two pivot points. Lift the panel up to free the pivot points and the wiring harness has enough play to let you drop the panel a few inches. 4) Now you should see the black flasher (small box shape). It hangs on the metal framework; slide it to the right to release from the framework. Push in the wiring connector catch and carefully separate the wiring harness from the flasher. Connect your new flasher and secure the flasher to the nearest wiring harness.
on May 04, 2018
Ac blowing out of defrost vents wheres the vacum lines?
Look on the intake manifold of the engine for a cracked hose. If a hose behind the control levers is leaking, you may be able to hear it with the engine idling. There is a possibility that the defrost door is operated by an electric motor too. Check the linkage on the door to see if it slipped off.
on Aug 08, 2015
How to force run the AC compressor to recharge AC in 2001 Infiniti QX4?
this will be a bad move as you are wasting money on a system that has a leak
until you fix that leak the gas is wasted
next by allowing gas into the system , the ac compressor will switch on when the pressure is sufficient
to see of the ac compressor is running simply look at the plate in front of the pulley and if it is spinning ,it is working
best advice , have an accredited ac shop check it out first.
on Jun 17, 2015
Not finding what you are looking for?