2011 Chevrolet HHR - Answered Questions & Fixed issues
2011. Why aren't both headlights working?
The diagram is part of headlamps diagram. When you turn on headlamps, is there voltage at the headlamp fuse? Use a test light to check for voltage. If the fuse isn't hot, pull the relay, in diagram, use a jumper wire between cavities 30 and 87, note the diagram, That is switch side of relay, left side in diagram. Any reaction from headlamps when using jumper wire? The right side of relay, in diagram, is the control side, control side needs voltage and ground in order to energize relay. Terminal 85 is hot all the time. Terminal 86 is grounded by the bcm. I agree with other post, voltage and grounds are important. good luck
How to check transmission fluid on 2011 hhr
Allow the engine to warm to at least 104 degrees.Shift it through all the gears.Put it in park.Remove the vent cap.Raise it on a lift.Remove the oil level control plug.It is below the right hand axle.The fluid should be level with the bottom of the plug hole.
Light work only on high beam
try and wiggle the stick back and forth vigorously and see if they come on or flicker see if your hearing an audible clicking noise when you select low and high beam if above dont fix it then your headlights will need to be diagnosed and replaced possibly a wire issue
Not finding what you are looking for?