20 Most Recent 2010 Chevrolet Silverado 1500 - Page 3 Questions & Answers

the pin out of the 7 pin connector Attached Thumbnails

Remove the button & resolve that part of the issue,so it either works or if tests bad-- replace it

what problem?______________vehicle scanner JBT-CS538C

My truck is in similar shape, you may have to use rad flush and make the coolant circulate better if it has rust blocking up the heater hose circuit. This is more common if the engine has been changed to one that sat for a while though. If your coolant looks clean check for vac hose couplers that may be off behind the intake manifold and inside the dash on the heater controls. Sometimes the multispeed fan switch melts inside and only works at 20% fan speed!, easy to fix with a good quality aftermarket control switch.

WELL YOU HAVE NEW VECHICLE UNDER WARRANTY.I WOULD SAY BAD GAS WILL CAUSE YOUR PROBLEM.BEST TO LET DEALERSHIP CHECK IT OUT.A FAULTY EGR OR IDLE AIR CONTROL VALVE WILL CAUSE ROUGH IDLING AND STALLING.BUT THOSE ARE NEW PARTS THAT STILL COULD BE DEFECTIVE.

It is on the left side of the steering column, below the instrument panel. It is easiest to open the driver's door, then lie on the floor and look up under the dash with a flashlight.

F1 and F2 are the door fuses for left and right, and F14 is Mirrors/Windows module, but you may run into problems because the radio is hooked up to the computer via a computer data network and may be confused by the addition of a new amp? https://fuse-box.info/chevrolet/chevrolet-silverado-mk4-2019-fuses-and-relays https://www.google.com/search?q=2021+Chevy+Silverado+1500+4+door+and+only+the+front+passenger+window+won%27t+work ....

In the link Firing order: 1-6-5-4-3-2 Distributor rotation: Clockwise. https://www.google.com/search?q=2000+chevy+silverado+1500+4.3+firing+order ..

c1500 (forgot the "C")/? 3 engine + diesel, not old engine, try new distrib ? or fully rebuilt not told exact part bad. ICM, sure. most folks that replace parts inside any distrib, (electronics only() do so wrong. it must have the heat sink thermal compound used, (thin) or it over heats,, rebuilts are best for sure maker CARDONE 1. the ICM has metal side, that must be thermal pasted. must. is use dow 340 compound or better. dow makes some that is 8x better for the fasted processor made by intel. that run super fast and super hot. so when I do care parts I use this, DOW TIM> TC-5022 340 up 5022 is nothing less than fantastic. use only thin covering thin is best, even .002" thick film even use old credit car to do that.

https://www.gmtruckclub.com/threads/1993-2500-lost-1st-low-gear.1476159/ Solenoid problem