Top 20
2011 Ford Edge Questions & Answers
Where is the crankshaft position sensor located on a 2011 Ford Edge.
Ok if it's the 2-valve 4.6 it's located on the front end of the left head. If it's the 3-valve one on each side. If it's the 3.5-3.7 or the 5.0 it will be located at the rear of the heads one is behind heat shield. An if you have the 6.2 it will be behind the intake manifold
Rear window defroster not working
Check obvious things first, fuses. Pull out your manual and look for locations. Second, there should be 2 wires going to the grid on the rear window defroster. Make certain they are still plugged in and the tabs have not been broken off, frequently happens at car washes when washing rear window. Third, take a close look at the grid of wire on the glass, looking for scratches. If scratched, you may be able to repair with a rear window defogger kit from your local auto store
Ignition off,running lights come on
It sounds like the common problem that the driver door switch sensor is defective and the car thinks the door is open all the time. Repeated closing the doors usually turns off the indicator and everything works fine. There is an entire driver door module for the latch and sensor that has to be replaced if this is the case.
Rear tail gate opens then closes again by it self
obviously a problem with the auto mechanism , is there a sensor located , see your owners manual, in a particular area that has to bee kept clear and you may have inadvertantly placed something over the sensor , just guess as something must be telling the tailgate to shut , with the age of vehicle is it still covered under makers warrenty ? i'll look into the sensor thing
Wiper washers
try to blow air into the washer hoses see if maybe there is a clog. why did you replace the wiper motor if it is only the fluid not working or I maybe reading it wrong . if the blades are working and the pump is pumping fluid then I would bet to say the hoses are clogged good luck
Not finding what you are looking for?