Top 20
2010 Mercedes-Benz Sprinter Questions & Answers
If I buy a new central locking key for my sprinter can I programme it myself ?
Def not,
Take it to a key cutter with appropriate software to mate it to your spare key
As a second note keep your key bunch light on 2008 sprinter or you'll break the esr ring
Electronic sensor ring - big bucks to fix and lots of downtime. This happened to me.
Esr ring if it goes will leave electronic solenoid in steering lock engaged and once you've had the sprinter put on the back of a truck and taken to main dealer they replace key box and then everything has to be re- paired with ecu
Big big bucks.
But a great van :-)
10/23/2015 6:37:52 AM •
2010...
•
316 views • 1 helpful votes
Steering wheel won't turn,its stuck and the key will not turn and engine can not be started
id say the 1st and the last symptom is caused by the middle symptom , to figure out whats wrong with that
1) do you have the correct key for that truck, folks that have more than one of these can mix up the keys for them , even repair shops can do it as well
(2) key damaged ??? keys get damaged all the time
(3) lock damaged ??? locks can become broken inside especially if one sticks the wrong item in there somehow
8/13/2015 11:24:52 PM •
2010...
•
282 views • 0 helpful votes
What type of code reader for a sprinter
It should be any code reader for 1996 and up vehicle which is OBD2 then google the code and it'll give you a list of possible causes or call your local auto parts store, give them your code and they'll be able to figure it out. O'reilly Auto Parts would be my opinion. And if you dont want to buy one because they can get pricey they do free engine light checks. It'll look something like "p0204" something of that nature.
7/8/2014 2:24:47 PM •
2010...
•
190 views • 0 helpful votes
How deep is pinion adjustment
wow its not deep ? you have to set the preload so that it requires 5nm to turn the pinion
5/15/2014 4:18:52 PM •
2010...
•
170 views • 0 helpful votes
All electric windows will power down but not back up?
i would say its the switch ,is it the same from all switch's ? the fuse is USUALLY for up and down ,BUT, they may be seperate, as you say wont all go bad at the same time so have a look at fusebox the lid will have a list of the fuse functions
5/17/2014 4:50:25 AM •
2010...
•
94 views • 0 helpful votes
Loss of power
Pull up the diagnostic error codes with the help of diagnostic computer and repair as necessary.
Both the ASR (Anti Slip Regulation) and ESP are concerned with the brake system. ESP is the latest one which includes in it ASR, BAS, ABS and ETS in a single control module. It uses steering angle sensor, Yaw rate sensor, acceleration sensor and all wheel sensors to decide which wheel to brake.
In short, delete the error codes and calibrate the sensors.
2/27/2014 1:32:28 PM •
2010...
•
361 views • 1 helpful votes
WHERE IS THE FUSE FOR TAIL LIGHT
EITHER IN THE ENGINE BASEMENT OR UNDER DASH BY DRIVER SIDE, BUT! IF ONLY ONE LIGHT DOESNT TURN ON REPLACE THE BULB OR CHECK FOR CONNECTION PROBLEMS. ONCE YOU GET A BLOWN FUSE BOTH LIGHTS WONT TURN NOT JUST ONE GOOD LUCK
11/1/2013 1:47:19 AM •
2010...
•
2,585 views • 0 helpful votes
Interior lights
do you have voltage at the bulb when the lights are on, sometime the connection needs cleaning
11/4/2013 2:50:38 AM •
2010...
•
1,006 views • 0 helpful votes
Engine wont turn over
lets see is key charged,or starter relay or solenoid working
11/28/2013 7:35:07 PM •
2010...
•
240 views • 0 helpful votes
Engine won't start
no ground, check your cables. also inspect fuses
11/28/2013 7:33:23 PM •
2010...
•
130 views • 0 helpful votes
Not finding what you are looking for?