20 Most Recent 2011 Mitsubishi Lancer Questions & Answers

0helpful
1answer
0helpful
1answer

ENGINE CODE PO68A ENGINE CUTS OUT

I googled, (you can too) see this: http://upkeep.us/OBDII/OBD2/Mitsubishi/piart.php?art=822 Other people seem to have similar problems. there may be a "hidden" recall Sounds like it could be a dangerous situation. I'd get it fixed before someone gets hurt, or contributes to an accident. Cheap health insurance!
2/27/2015 1:58:51 PM • 2011 Mitsubishi... • Answered on Feb 27, 2015
0helpful
1answer

Left speaker in lancer not working

test the speaker. connect a 1.5vdc battery to it, (yes, unplugged) does click? then its good enough to make noise. use a test speaker at the connector, that works.? if not the radio is bad or the wire are cut. to prove that, connect a speaker directly to the radio left pin. works , good radio. i cut the line at the radio as soon as the speaker tests good because grounded out (shorted) lines blow radio amps to smithereens. can pull the radio first. then bench test it. its super easy with one test speaker . and a 12v power source. but be careful many radios brick (shows, enter code) if you pull it. get your radio code first and this solves this issue. many radios kill audio only bricked, left and right channels. but tunes ok .
6/19/2014 3:26:14 PM • 2011 Mitsubishi... • Answered on Jun 19, 2014
0helpful
1answer

Left speaker not working in lancer

unplug the the connection for the left speaker and get a contact cleaner and spray both female and male conection allow 25 second and then plug it back again, or sometimes check remote volume for the left speaker.
6/18/2014 11:59:45 PM • 2011 Mitsubishi... • Answered on Jun 18, 2014
0helpful
1answer

How to fill transmission fluid

Manual or automatic? On a 2011 why are you "filling" it? I’m happy to assist further over the phone at https://www.6ya.com/expert/josh_8f8ad0a8f7e0e6d3
6/6/2014 5:42:12 AM • 2011 Mitsubishi... • Answered on Jun 06, 2014
0helpful
1answer

I installed a short ram

WOW! Don't even know what to guess on this one. I do have a suggestion though. Go to the manufactuers web site (of the short ram air intake) and see if they have a work around to make their product work with your car.
6/4/2011 1:02:08 AM • 2011 Mitsubishi... • Answered on Jun 04, 2011
0helpful
1answer

Mitsubishi Lancer glx 2003 Alarm goes off only when car starts, Can't switch it off

the dash lamp marked SECURITY IS DEAD all the time.keyon and off? fuse #2 missing,(security fuse)? remove the remote battery so the bad buttons in FOB do not trip the alarm I',m sure you mean factory alarm is in the car. in USA we can scan the OBD2 port and see why any alarm tripped. lots of ways there are, door switches, etc. lost the users manual tell you on most cars the alarm need be enabled. and how. most say , open the door with good fob. then do not lock the door using fob and alarm is not active. but with a dead fob how? (car came new with 2 fobs) lost 2nd? my answers are for USA spec cars only, not world wide. ever. doors with keyless entry system is what they call this. fob locks. simple have you examined the whole car for wiriing harness hacks that put in any kind of 1000 aftermarket alarms here, this is first. is the horn honking? the same horn the steering well uses or some other horn hacked in to car. ( we inspect all this first) the factory ETACS as its own fob RECEIVE inside (antanna) there are 3 fuses to ETACS. fuse 22 do not pull that it kills vast other things too. Fuse 2 and fuse 15 goes there but not sure what happens pulled but seems the interior door lock buttons go dead. doing that.. here is my only cure. pull the battery NEG lug for 1hour, or more even overnight see if ETACS , resets (well it sure will) but do so and not go into alarm and first remove the FOB battery (on all fobs for this car) see fob guts below 1 coin cell there , remove it, now bad buttons do not cause system to fail. open doors only with metal key. all instructions for this car assume the below is not bad. and buttons love to fail even SHORTED.(BAD) fob-undefined-undefined-0.jpg
2/26/2023 1:57:05 PM • Mitsubishi... • Answered on Feb 26, 2023
0helpful
1answer

Mitsubishi Ck2 lancer 4g15 dohc, car will into reverse and move but doesn't go forward

No year car told no country told, so no manuals for it , lacking key facts.
  1. check all fuses.
  2. scan the PCM(TCM) see tranny errors.
  3. google how to diagnose 5 decades (1973 up 4G engines) and read how to fix them all or learn to post year car and country.
  4. top cause, modern cars, box is bad, pump weak , pump reg bad, seals leak inside, solenoids, bad or pressure reg solenoid bad or bad 1st gear clutch pack. and more, even bad gear selector cable. PRNDL , D and L are farther so , cable may not reach D or L. good luck find this with weak posts of missing key facts.
10/2/2022 7:26:36 PM • Mitsubishi... • Answered on Oct 02, 2022
0helpful
3answers

Can you explane what is

Iam getting error 92 ETV MTR FB and my car is producing a laughing sound when i press brake pad.
9/24/2021 4:31:11 AM • Mitsubishi... • Answered on Sep 24, 2021
Not finding what you are looking for?
2011 Mitsubishi Lancer Logo

Popular Tags

28 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Lancer Mitsubishi

  • Lancer Mitsubishi

Most Popular Question

diesel injectors mitsubishi lancer 2011

  • Cars & Trucks
Loading...