20 Most Recent
2011 Toyota RAV4 Questions & Answers
2011 rav4 problem with a/c vents
If I remember right that has to have a source of vacumn from the engine. Check any hoses (small about the size of dime coming out of the firewall to the engine it sounds like it came loose also is your vehicle idle higher or miss anytime now? we will get you going just work with me
Rav4 engine light & auto lsd red blinking lights on
You recently changed the engine air filter and now, the Check Engine light is on and the LS D light flashing. When you opened the filter housing, you inadvertently disconnected a small hose that is connected to the housing. (See photo) This will result in the lights mentioned coming on. Simply reconnect the hose (it can be simply pushed in) and the engine will perform normally. The Check Engine light will still be on though. The error code will need to be cleared using a dongle that connects to the OBD ll connector under the driver side dashboard and an a smartphone app that connects to the dongle through Bluetooth.
Car won't start
That is battery/battery terminal/corrosion problem.
Please clean the terminals really good, and not on the outside, on the inside.
The metal (lead) of the battery terminal and the band (copper) of the terminal need to be shiny bright on the inside.
These need to be cleaned periodically, like about every 6 months or a year.
Also, take you car to a honest shop and have your battery tested.
God bless your efforts.
2011 Toyota rav4 p0171
code p0171 refers top system too lean, bank 1===causes---intake/exhaust leak--air system---MAF/VAF sensor--fuel pressure/pump--injector/s ----HO2S
Do I need special tool to remove door panel on 2011Toyota Rev4?
No...just in this order door handle screws first.use a flat head screw driver between the metal door and door card and just twist the screwdriver until you hear it pop.tackle the sides and bottom before the top.the top should free itself when you slide the whole door card upwards.when refitting slide the top into position before pressing home the studs on the side and bottom.i usually just use the edge of my fist to tap them home.
How to remove interior trim on passenger side from back to front to install wiring for tow bar
The trim may have several plugs that hide bolts/screws. Look for those and remove with care using a nail remover or flat object like a putty knife. after removing any screws, the trim may come off or have to be pried off. Some overlaps overs and it is better to remove the ones that are on top first. The rubber trim along the edge is usually pliable and with give. Make sure to remove seatbelts and the like if attached to the same trim. Door trim may not have sufficient space to hold wires but they may have to be moved to access under the carpet or channels where the wires may be run. Be sure to remember the order of removal and retain all fasteners. Be very careful to put it all beck correctly and not to smash or snag any wires. Take special care when running through holes in frame not to allow it to contact sharp edges. Tape over or cover edges where needed.
For your problem, look for clips around edges that may have to be released.
Not finding what you are looking for?