20 Most Recent 2001 Nissan Frontier Questions & Answers


main ignition fuse is only for just that...

if you checked that the circuit to that power outlet is OK, including the wiring, maybe the jack itself is bad

disconnect it, then use jumper wires to the battery to see if it powers on

2001 Nissan... | Answered on Apr 09, 2019


REM wire connects to the REM wire at the back of the aftermarket head unit. REM stands for remote and is typically a blue wire. Hope this helps, if you need further assistance I would be happy to help you. Please feel free to contact me at:

https://www.6ya.com/eugene_aa01c1a9fa4c2ed9

2001 Nissan... | Answered on Mar 08, 2019


A key question is whether the power brake assist is normal while driving. If it isn't, you may have to depress the brake pedal 'hard enough' to actuate the ABS system. Do you notice typical ABS modulation of the brakes while the pedal is 'hard'?

Personally I'd think any fault with the ABS itself would throw a code, either setting the ABS light on the dash or providing something in the OBD-II scan. Have you observed any codes resulting from, say, a free scan at AutoZone?

2001 Nissan... | Answered on Feb 01, 2019


Look on the following link where's there's images which will help you identify and find it:

2001 nissan frontier throttle motor Google Search

2001 Nissan... | Answered on Mar 14, 2017


Evaporative System Canister Vent Control Valve Circuit http://www.autocodes.com/p0446_nissan.html

2001 Nissan... | Answered on Dec 05, 2016


check / replace the battery in the fob key
use a scan tool to reset the ECM
Have this done by a service center conversant with nissan products as there is a special procedure to get the ECM to respond

2001 Nissan... | Answered on Dec 20, 2015


Some broken glass has jammed the diverter flap , dismantle it and clean out the broken bits of glass.

2001 Nissan... | Answered on May 28, 2015


If do not have deep stick,at bottom is screw.

2001 Nissan... | Answered on Mar 02, 2015


Tools needed:
10mm socket
14mm socket
player's
ratcheting wrench
long and short extension
breaker bar or Big wrench so you can put on ratchet to give you more leverage.

Starter is on the passenger side of truck attached to the transmission.

Start by disconnecting the battery. Something that will greatly help from the top is disconnect the wire from the starter going to the positive battery wire. You will thank god for this later. (it was a pain in the ****)
Remove nut from positive side of solenoid
Remove 10 mm bolt holding stainless steel lines
Remove 14 mm upper and lower bolts (I used ratcheting wrench with extension and 1" wrench to give me leverage)
There is one more 14 mm short bolt that is above tranny pan that you will need a long extension to get to.

Once you remove all bolts starter should almost fall out of place minus wire that you disconnected earlier. The one I had, had gotten caught up with other wires and I finally got aggravated and just broke the wire off to get the starter out. This is not a big deal as the new or re-manufactured starter will have this wire.

Installation:
Make sure to line up the plate right and thread in the top bolt hand tightened.
Do the same as with lower bolt.
line up bracket and thread in the short bolt tight so you don't have to mess with it again.
tighten stainless steel line back together.
Have someone push the wire up you in the upper part of the engine area and plug wire back in.
tighten all bolts and make sure to attach positive batter cable wire to starter.
Reinstall battery and give the key a turn.

Good Luck and please rate 4 thumbs up for the answer

Nissan Frontier... | Answered on Jul 11, 2019


Ask Google you should find them there

Nissan Frontier... | Answered on May 18, 2019


Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me and I thank him even today
They have full manuals and it's verrrrry cheap

Nissan Frontier... | Answered on Apr 14, 2019


Po102 faulty mass air flow sensor. Po301 ECM. malfunction.have pcm checked.also make sure have a good battery voltage .if alternator or battery bad.that will cause ECM malfunction.check those things also.

Nissan Frontier... | Answered on Mar 14, 2019

Not finding what you are looking for?
2001 Nissan Frontier Logo

16 questions posted

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Frontier Nissan

  • Frontier Nissan

Most Popular Question

01 frontier brake issue thinking abs

  • Cars & Trucks
Loading...