Top 20 2001 Nissan Frontier - Page 4 Questions & Answers

Sometimes if they get dust,dirt,snow or ice in them they won't "click".

Need a make and model buddy

What have you checked ? Is the pump getting power from the relay ?

Have you checked the fuses?

VALVE CLEARANCE ADJUSTMENT Application In. (mm) Intake .010-.013 (.26-.34) Exhaust .011-.015 (.29-.37)

Here's a link Corey on your code. P0463 Fuel Level Sensor Circuit High Input

You should have torque to yield bolts there. That means single use - you need to buy new bolts. Then, you would torque to spec (maybe 10-12 ft. lbs.) then an additional 65 degrees of tightening rotation. Call your local auto parts supplier. Repair Guides Specifications Torque Specifications AutoZone com

Either bleed all lines again or check master cylinder. Start with a slow thorough bleeding job making sure master is never low of fluid.

follow the upper radiator hose back to the motor,it is inside that metal thing that is bolted to the motor and connected to the hose

all the blinkers should be on the same fuse, fuse panels are normally located on the drivers side of the dash board or under it.

Maybe you push wrong button? PLEASE BE MORE SPECIFIC AS TO THE SYMPTOMS YOU EXPERIENCE, UNDER WHAT CONDITIONS YOU EXPERIENCE THEM, AND WHAT DIAGNOSTIC STEPS YOU HAVE TAKEN. Also, it is VERY IMPORTANT that you include the YEAR of your vehicle.

Could be someone changed the locks since the truck was new. The dealer or a locksmith could tell you.

Your heater core is probably going bad. Make sure you have the proper thermostat installed also.

any way you want <shrugs> use a muffler cutter http://cliff.hostkansas.com/images/2010/CHAIN_CUTTER.JPG and use appropriate adaptors/ clamps to clamp that fiber glass packed muffler to your ride jerry-rig some hanger adaptor so your exhaust system doesn't flex too much when going over bumps

Here's a link to your code. P0448 Nissan Evaporative Emission Control System Vent Control Circuit Close

CALL DEALER WITH MODEL NO

Ground cable is bad broken or not grounded good

sounds like a bad actuator for the mode door. This actuator is an electrical motor that moves the door inside the HVAC box.

fax belt?

Apon turning the key, if you hear only a clicking sound. Replace the starter motors selonoid. This happends in most cases. You are unclear on the problem and dont have much details. Hope it helps though