20 Most Recent 2015 Chevrolet Cruze - Page 6 Questions & Answers

Behind the dash panel

If you mean RESET -all you do is remove the battery for more than 1 minute then reconnect it

When replacing an engine it's always recommended that you re-program the computers to match the new engine.

Have the codes read. The longer you drive, the worse it will get.

AutoECMs Buy Refurbished Auto ECMs BCM MAF ABS TCM GEM More

30-44at idle

around the 60 -65 psi mark for a petrol around 22,500 psi for a diesel pump

P0106: Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance Problem http://www.autocodes.com/p0106_chevrolet.html P0171: Fuel Trim System Lean Bank 1 http://www.autocodes.com/p0171_chevrolet.html P0101: Mass Air Flow Sensor Performance http://www.autocodes.com/p0101_chevrolet.html

Chevrolet Cruze?
Try this first, pop up your hood and check the battery. If your batt does not hold enough charge your electronic system will sense trouble/ system malfunction.
Try replacing a new battery and after installing a new batt. Reset the system.
Hope it help.
God Bless.

Try this for the back seat: Pull the back seat down. Unscrew all the bolts behind the back seats to release it from the brace. Pull the seat back off the rear deck and out of the car. Feel under the seat cushions for release tabs on both sides. Pull the release tabs to loosen the seat cushion. Push the seat belt buckles into the holes to prevent the seat from getting caught up in the seat cushion

It would be helpful if you give us a specific year.

Heat flap in mixer not closing