20 Most Recent
1997 Acura Integra Questions & Answers
Drivers rear power window stopped working
take a close look at where he cut the wires. you may see a little of the wire colours in the plug. why would he cut the connector off. with most people having a phone capable of taking photos I`m surprised no photo taken before this happening.
Car heater
Check your coolant level and make sure you have got no air locks or coolant leaks and make sure your coolant is circulating (ie your water pump is working)
If this helps let me know
Cheers
When you give it alot of gas it bogs down wasnt doing that before just started doing that just started
HelloThe
Engine and Automatic Transmission (not applicable to manual
transmissions) in this vehicles drive train are fully
electronically controlled by a computer called the PCM and TCM (Power
Train Control Module, Transmission Control Module). When a problem
like this or other drive-ability related problems occurs the computer
stores a record of the problem (there are of course some exceptions
to this, like the fuel pump, engine coolant temperature sensor and
MAF sensor for instance) in the form of a fault code in its memory,
to read these fault codes you must have the systems memory scanned
with a special tool. Once the fault code(s) are read you then must
perform the appropriate diagnostic testing to find and resolve the
problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED
TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD
EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always
check fuel pressure for correct spec for your make and engine type.
KIA Clarus 1999 radio code
Call dealer for radio code or go in person they will ask for vehicle identification number( vin #) on your registration.hope this helps! Sometimes you find it written on your new car manual .
How to Clean a Solenoid Starter in Acura integra car?
1) Keep the starter on a clean surface.
2) Clean the starter with lubricant cleaner.
3) Remove the motor from starter by removing the bolts holding the starter.
4) Clean the bolts also with the lubricant cleaner.
5)After the bolts are removed the stater will come out.
the inner cylinder connected to the starter will not come out.it will remain in place.
6) Properly clean all the components with lubricant cleaner.
7) Use cleaning brush and rag to clean all the inner components.
8) The starter is cleaned now.
8) Then reassemble all the components back.
This will help.Thanks.
Not finding what you are looking for?