2006 Chevrolet Cobalt LS - Answered Questions & Fixed issues
2006 chevy cobalt ls I have individual coils on s engine I swapped but my harness has a set up for a coil pack doing have to change engines?
You don't really need to swap the engine out. The coil pack is simply the electronics that controls when the spark plug fires. You could change the wiring set up to use a multi coil pack system but this could be very complicated and very expensive as you might need a specialist to do it for you.
You are probably better off converting the new engine to run on a single coil pack system. If you have swapped the old engine for another engine that is the SAME you might be able to transfer the parts off the old engine onto the newer one.
You would be safest asking a good mechanic near you if this is possible.
Need picture location of coolant bleeder valve for 2006 Chevrolet Cobalt LS with 2.2L engine
Doesn't have a bleeder valve .
Filling Procedure
Notice: The procedure below must be followed. Improper coolant level could result in a low or high coolant level condition, causing engine damage.
Close the radiator drain **** by hand.
Notice: Refer to Fastener Notice in the Preface section.
Install the water pump drain plug (1) if removed during the draining process.
Tighten
Tighten the plug to 22 N·m (16 lb in).
Lower the vehicle.
Important: Use a 50/50 mixture of DEX-COOL antifreeze and clean, drinkable water. It is necessary to maintain the coolant level near the cold fill line on the surge tank to insure all the air has been purged from the cooling system.
Slowly add a mixture of 50/50 DEX-COOL antifreeze and deionized water to the cooling system until the coolant level reaches and maintains slightly above the cold fill line on the surge tank. Refer to Approximate Fluid Capacities.
Install surge tank cap.
Start the engine.
Run the engine at 2,000-2,500 RPM for 3 minutes.
Allow the engine to idle for 30 seconds.
Shut the engine off.
Top off the coolant as necessary.
Inspect the cooling system for leaks.
Rinse away any excess coolant from the engine and the engine compartment.
2006 cobalt.replaed starter relay fuse all lights come on dash ect. fuel going to fuel pump but wont crank over
Are you positive the battery is good? Did you try to jump it ? Make sure all cables are clean and tight. When you say "won't crank over" do you mean the engine doesn't turn at all? If not, I don't know why you think the fuel pump would be the culprit. If it cranks and doesn't start, I don't know why you replaced the starter.
Disconnecting the battery doesn't reset the light. You need a scan tool for that unless you get lucky and fix the problem and go through enough cycles for it to go out on it's own.
Take it to Autozone or Advance or somewhere and have them read the codes. They do it for free for you. (They are hoping you will buy parts there) They can reset the light as well.
2006 Chevy Cobalt LS rough idle
I would recommend cleaning the throttle body with carburetor cleaner, remove the air inlet to the throttle body and try cleaning. After cleaning will be hard to start but should solve your issue
Google com
Never changed your Power Steering Fluid, every
3 years, when you changed your trans fluid?
Steering Rack maybe failing
Should last close to 15 years or more
Engine power reduced displayed
sounds like the camshaft sensor or the crankshaft sensor, either way I think your car is being recalled for a faulty ignition switch which could turn off by itself.
How to open my truck on 2006 cobalt
can u get to the bat underneath the vehicle and very carefully touch one to a good - grnd on vehicle and touch other cable or heavy wire to posie + on the bat...careful!!...have a friend help...
Vacuum Leak
with engine idle ...take a wd40 or equivalent listen to engine sound if you spray on the leak then engine will change soundor listen to small wisle
Cobalt anti theft
thank gm's "quality" passlock system. try turning the key on and off a few times, sometimes that resets the security light on the car. also...MAKE SURE HE UNHOOKS THE BATTERY FIRST! lol
06 chevy silverado distributer replacement
Make sure engine is on #1 cylinder. Remove #1 plug Hold finger over hole and turn engine over clockwise until compression is felt.continue turning engine untill timing mark lines up. Find #1 cylinder On Distributer cap. Position rotor app.42 degrees before #1 Insert dist. in eng. should rotate clockwise until seated. If only goes part way down and won't seat all the way down remowe look down in eng.and make sure oil pump drive rod is alined.
2006 Cobalt LS Coupe Intermittent Starting Problem
sounds about right, probably is ignition switch, reason you don't get codes is because if power is'nt connecting to engine while problems occurs then ecm won't pick it up. you should have 2 ignition switches, (the lock cylinder and key switch, the other is the electrical, usually located under the dash, and commonly atttatched to the column close to the firewall, check connections first, it may just be a loose plug in connection
Sound from undercarriage when braking
See if the noise is also getting louder as you turn one direction or the other. The rubber rubbing sound doesn't ring bells but I suspect the bearings going out on one of your wheels. If it makes a noise when breaking but get louder or better as you turn one direction or the other I would bet bearings. I would look at that.
Car alarm goes off when door is open
Alarm reset has been set to sensitive or a faulty unit in either case have an auto electrician have a look at it to diagnose any problems that maybe going on.Hope this helps
Not finding what you are looking for?