20 Most Recent 2010 Chevrolet Cruze 2.0 Questions & Answers


u joints in lower part of column probably have rusted and need replaced

2010 Chevrolet... | Answered on Nov 02, 2016


possiable fusable link between battery and main fuse box under the hood or near the starter. follow all the positive wires from the battery one of them has the fusiable link this part of the wire will usually look like its been added with some heatshrink . to tell if its bad the wire will feel soft and bendable. if its good it will feel stiff.also check all fuses under the hood

Chevrolet Cruze... | Answered on Dec 15, 2019


What fan ? What year is the vehicle ?

Chevrolet Cruze... | Answered on Oct 02, 2019


Howard I see Derrick is busy giving his worthless answers again. You should have two fans. The one on the drivers side is the regular engine cooling fan. It should come on once your car has reached the proper temperature that your thermostat is set for.( they come preset) Actually it runs most all the time. The one on the passengers side is for the A/C Condensor.
When you run the A/C it makes your vehicle run hotter so that fan should come on only when the A/C is running. It cools the freon going through the Condensor coil helping the A/C blow colder and helps keep the vehicle running cooler. Hope this answered you question.

Chevrolet Cruze... | Answered on Aug 27, 2019


Disconnect the battery cables for 3 minutes it should have cleared already after the repair but do this and if the light comes back get the codes read they are fresh ones at autozone and see what comes up

Chevrolet Cruze... | Answered on Aug 25, 2019


That is not a valid code for your car. If it is P1800, that is the code for a transmission control module Power Control Relay Circuit Open which can lead to harsh shifting (among other things).

Chevrolet Cruze... | Answered on Aug 18, 2019


please advise what about the code 35 of chevrolet cruze 2010

Chevrolet Cruze... | Answered on Aug 17, 2019


Some fixya user told me a website reliable-store. it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

Chevrolet Cruze... | Answered on Aug 15, 2019


https://www.cruzetalk.com/threads/fuel-pressure-sensor-location.230338

Here is a forum talking about your sensor. It is attached to the fuel pump in the fuel tank. This forum talks about other possibilities of a bad signal.

Chevrolet Cruze... | Answered on Aug 15, 2019


Watch this video, Cheryl. It shows you how to open the trunk.
https://youtu.be/z00xU3LyS54
Good luck

Chevrolet Cruze... | Answered on Jul 02, 2019


Battery is shot. Modern batteries can test near full voltage and still not be able to deliver much current. If you wish to be certain, have the battery tested with a tester capable of measuring the CCA rating. Believe you will find it's only capable of providing less than half the rated output. Probably even less.

I use a Solar BA-7 tester to check all my batteries and charging systems.

https://www.amazon.com/dp/B0015PI7A4/ref=cm_sw_r_cp_apa_i_HnSgDbKD089E9

Battety voltage in a modern car means is still important, but it's actually less important than how much current the battery is capable of delivering.

Chevrolet Cruze... | Answered on Jul 02, 2019


Considering the age of the battery for that year car, before you do anything else, try a jumpstart to see if the car will start. If so, you may just have a weak battery that needs to be replaced.
Unlike cars of old, modern car computers will deny power to critical circuitry when the battery falls to a certain level. Without getting too involved in explaining, this protects the sensitive circuits of your car from ill effects of a battery on it's last leg. Lights on and no attempt at start is indicative of intentional computer protect.
What a weak battery did to fry a cars clock windings in the 50's and 60's would certainly wreck a lot of options in the modern car so the computer protects those circuits through power denial.

Good luck.

Chevrolet Cruze... | Answered on Jun 18, 2019


Your local auto parts store o'reilly's, auto zone etc can till you for free

Mike

Chevrolet Cruze... | Answered on Jun 05, 2019


ya i know that what is error code 91 it is that ur car key is not there & if shows error code 35 then ur car remote key cell losing his power exchange with that cell & ur car is ok

Chevrolet Cruze... | Answered on May 25, 2019


If you are absolutely certain the fuel pump is functioning correctly then check your efi fuses/relays

Chevrolet Cruze... | Answered on Apr 29, 2019


If you have a second person available get them in the driver seat. Position yourself at the caliper and have them pump the brake pedal 5times and hold down, open the bleeder on the caliper you changed until fluid, or air flows out then close bleeder. Repeat until only fluid flows out with no bubbles.

Chevrolet Cruze... | Answered on Apr 29, 2019

Not finding what you are looking for?
2010 Chevrolet Cruze 2.0 Logo

2 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Cruze Chevrolet

  • Cruze Chevrolet

Most Popular Question

2010 chevy cruze 2 0 diesel heavy notchy

  • Cars & Trucks
Loading...