2010 Chevrolet Cruze 2.0 - Page 5 - Answered Questions & Fixed issues

It would be helpful if you give us a specific year.

Heat flap in mixer not closing

Initial torque 44 ft lb when all done in sequence, Additional 1/2 turn with regular wrench.

for the best solution of your problem visit this site Chevrolet Cruze

Scanner will not connect ?

Find the intake air leak.

Take your car to your local parts shop. Most will read the codes from the computer. That will tell you what's broken.

broken handle or cable. or you locked the hand release for the trunk, if so equipped, without knowing it

My guess is the ignition switch needs changing

i would expect the reason for the error code is there is a build up of carbon etc on the sensor so is not transmitting the correct information , try using a fuel addative that covers the catalytic convertor as well as the engine/fuel system , take for a longish drive at a good steady speed so the engine gets to a high working temperature , you may have to repeat this to get a good result but much cheaper than replacing the part , if this clears the error code then i'd advise using an addative every 10k to keep things clean and working better , you should get a bit better fuel economy as well

Its a factory recall If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541

If you are referring to the tire light on the dash, that is a LOW TIRE indicator. Tire pressure needs to be adjusted to proper air pressure and then drive the vehicle for about 2 mile and the light should go out.

ask your local tire station

the 4 bolts on the bottom of the seats

CarcareKiosk.com has a video for 2011-2014 cars . I am not sure what year yours is . Input , Battery removal for ( whatever year our car is ) in your search bar . Several options should come up , Click on videos and that should help you .

possibly a circuit breaker that they use rather than a fuse that will automatically reset after it cools down. Possibly a wiring problem shorted to ground.

You will need an impact driver to get that screw out, if it won't come out with an ordinary screwdriver. Alternatively, you can also get the screw loosened a bit with a hammer and a chisel as well.

It means the oil needs to be changed! Im pretty sure on this. if not take it to any auto parts store and they will scan and tell you for free. but the light has to be on.

we change thermostats often at my shop. don't buy a cheap replacement either. if you can, get one from the dealer

my cruz car has a code erer 91 what is this please tell me