2007 Chevrolet Malibu - Answered Questions & Fixed issues
Code C0561 for a chevy malibu
co561 System Voltage unstable,, po751 Shift solenoid A CKT
performance or stuck Off,, po700 Trans Control Sys. Malfunction
these are OBD codes, hope that helps....
2007chevy malibu
You must get the engine control computer scanned for fault codes, this is the first thing that must be done before any diagnostics can be done to find the problem that has put the engine in "LIMP" mode.
2007 Chevy Malibu won't start, odometer reads error
The odometer will display 'error' if an internal IPC memory failure is detected or if there is a serial data communication fault between the ECM and the BCM. IPC instrument panel cluster .
Circuit Description
The communication among control modules is performed through the GMLAN high speed serial data circuit and the GMLAN low speed serial data circuit. The modules that need real time communication are attached to the high speed GMLAN network. The body control module (BCM) is the gateway between the networks. The purpose of the gateway is to translate serial data messages between the GMLAN high speed buss and the GMLAN low speed buss. The gateway will interact with each network according to that network's transmission protocol. Refer to
Body Control System Description and Operation for more information about the gateway.
Your best bet is to take your vehicle to the dealer , sorry !
How can we unlock a motor of a 2007 Malibu
It will depend on why it is locked in place. Pull the spark plugs and check for water, also drain the oil and check for water. If this is the case the engine was hydro locked which usually means a bent crank rod and complete rebuild or replacement will be required. Sorry!
Where is the ignition control module located in a 2007 Malibu?
What engine does yours have ? 2.2 , 3.5 or a 3.9 L , there isn't an ignition control module .
The engine control module (ECM) controls all ignition system functions, and constantly corrects the spark timing. The ECM monitors information from various sensor inputs .
Now , what seams to be the problem ? No spark ? Crankshaft position sensor could be the problem or cam position sensor .
Now ,what
Misfire on number 3 2.2
Have you cleaned out the throttle body? Spray thoroughly, and wipe out after...also check air filter and use gas tank injector cleaner...one or two bottles...hope this helps.
Not finding what you are looking for?