2008 Chevrolet Silverado - Page 9 - Answered Questions & Fixed issues

Computers rarely just die. If so it is a very tricky undertaking. It can destroy an engine if not properly installed and flashed by a professional mechanic. Nine times out of ten it won;t even let the vehicle start. They are not universal fits and require flashing with software to work correctly. What makes u think something is wrong with your computer? I have no details so I can't give you a reliable answer.

Get a new one .

Have you checked the fuel pump?

no it does not

Check the fuses and then use an electrical probe to insure power at the switch. If you have power thru the switch check at the motor. If power is there touch the no power side with ground. If it runs trace the harness back and look for a break or bad ground point. Contact the dealership and ask the parts and service departments if this is common or if there has been a recall. Good luck.

Yes, that would be power from switch to starter solenoid to make the starter crank the engine.

Which engine ?

Sounds like the shift cable has broken

Hey Sam... how about a trip the ;ocal dealer ..or maybe O'reilly's or autozone... smile and ask for some help... the dealer's service manager should be able to help...

some do

You should check out http://www.silveradosierra.com/mobile-electronics/cd-stuck-t56201.html.

You got water in the controls somewhere, as to where you just have to look.

I would check voltages on the connector attached to the back of the radio. It is possible there is another inline fuse there, or a problem somewhere in the wiring harness.

First step is to check for error codes (DTCs) using a code reader and follow up if any.

Sounds like the blower motor is going bad

check and make sure your harmonic balancer is still in one piece, sometimes this rubber comes free and just spins to make that noise.

Sounds like you didn't add oil , when freon goes the oil goes also. When you say locked up , you mean the compressor won't turn when the clutch engages? Either too much freon or the oil was gone from the system when you put freon in it.

make room by unbolting the y-pipe if necessary.

i have the answers to your codes http://www.troublecodes.net/pcodes/p0102 and the second one http://www.troublecodes.net/pcodes/p0308 i hope this helps

only if you put in the bluetooth codes for the phone