20 Most Recent 2005 Chrysler Pacifica Touring Questions & Answers

0helpful
1answer

2005 Chrysler Pacifica. Fuel sending unit not working on it?

Clean the connector with electrical switch cleaner. A new sender is $110. A new pump and sender is $500. https://www.google.com/search?q=2005+Chrysler+Pacifica.+Fuel+sending+unit ..
3/22/2023 5:07:34 PM • 2005 Chrysler... • Answered on Mar 22, 2023
0helpful
1answer

Windshield Washer Pump connection to the water bottle

Take the rubber hose loose at the nozzle, try the washer. if water comes out then the little hole in the nozzle is stopped up. Use a small needle or stickpin to clean it out while someone works the washer switch.
11/28/2017 3:38:56 AM • 2005 Chrysler... • Answered on Nov 28, 2017
0helpful
2answers

2005 Chrysler Pacifica: Brothers and Sisters Help ME!!!! I had water pump & Timing done and now my upper radiator hose continue to pop-off. Please advised Carefully (As this is my only source of t

Usually, hoses pop off if the radiator/expansion tank cap is incorrect/broken. Find out if this "mechanic" changed the cap, if they did, get the old one back or get a replacement from the dealer. I have never gotten a dependable replacement from any parts stores. If they didn't change it, change it anyway and see what happens.
3/9/2017 6:00:27 AM • 2005 Chrysler... • Answered on Mar 09, 2017
0helpful
1answer

Pacifica steering pulls to the left and car shakes

check tires --have rebalanced ,make sure proper air pressure ,also check brakes --then check front suspension tie rods /balljoints control arms c/v axles
10/4/2016 11:29:20 PM • 2005 Chrysler... • Answered on Oct 04, 2016
0helpful
1answer

My 2005 Pacifica touring started making a crackling sound then lost all power

I would need to hear what the noise was to diagnose this.
9/24/2016 3:16:09 AM • 2005 Chrysler... • Answered on Sep 24, 2016
0helpful
1answer

Brake lights (all 3) not working brake switch and fuses ok, strange mechanical switching sound from gear selection lever area when in park. Any ideas

Possibilities are brake switch, fuse, or grounds. Since all three are out. Grounds are usually on the drivers side attached to the frame by the left tail light assembly. I would recheck the fuse if you didn't pull it out and look at it. Corrosion can cause the lights not to work, but the fuse is good.
7/20/2016 3:28:58 PM • 2005 Chrysler... • Answered on Jul 20, 2016
0helpful
1answer

How can i fix a p0522 code that is read by my engine light? Can i reset it and forget it? Or is it dangerous?

code p 0522 refers to engine oil pressure sensor/switch---low voltage === causes --wiring short to ground ---engine oil pressure sensor/switch---ECM any reference to oil pressure warnings should be taken seriously as a destroyed engine is a result of inaction first get it to an accredited service shop that handles your make of vehicle and have the oil pressure checked with a mechanical gauge if it not a pump/ oil level problem , replace the sensor
4/20/2016 4:35:11 AM • 2005 Chrysler... • Answered on Apr 20, 2016
0helpful
1answer
0helpful
1answer

Air,lights,radio,wipers,windows stopped working

check your fuses
9/15/2015 1:30:42 PM • 2005 Chrysler... • Answered on Sep 15, 2015
0helpful
1answer

Oil light stays on when engine is started

If oil level is okay and the engine has pressure like no knocking the sending unit is bad. The dealer will charge about 85 to change it don't even try to do it yourself. It took a garage 6 hours to change it. It is in a bad spot and unless you want to rip the connector of it and hope it stays on the new one, it is easy to do . If you want it done right take it to the dealer
9_23_2015_9_30_21_pm.jpg

oil-light-stays-when-engine-started-b3zvadmhtac1x5ozcoi50jrx-5-2.jpg
7/14/2015 8:27:59 PM • 2005 Chrysler... • Answered on Jul 14, 2015
0helpful
1answer

Question 2 parts-- 1--what do ball joint or wheel bearings cost to fix on a 2005 pacifica tourning with 69500 miles on it..2--same with inner or outer tie rods to fix. thank you.

It shouldn't need either with only 69k. Odds are you have a break system problem. Check that first at a competent brake shop or your dealer. Brakes are an important safty system and repair should not be delayed.
7/5/2015 2:25:41 AM • 2005 Chrysler... • Answered on Jul 05, 2015
0helpful
1answer

I found a pics of wire connected to the bolt in the left motor mount bracket what is it for

There are two fans on for air and one to keep the engine cool the engine one is not working so that wire was the ground or the power wire and needs to be fixed. The wires to both fans go to the same area near the bottom of the battery area. Follow those wires and you will find the broken one and splice a new wire in
6/8/2015 12:03:33 AM • 2005 Chrysler... • Answered on Jun 08, 2015
0helpful
1answer
0answers
0helpful
1answer

What's the difference between the master cylinder with or without traction control

The parts-store gave you the wrong part. If you still have it, take the old part with you to the parts store. Just match it with the new one before you pay for it.

As for the traction-control matter, the difference has little to do with the master cylinder. In traction control, a computer and wheel-mounted sensors keep the wheels from skidding by turning the hydrolic pressure on and off to the individual wheels according to which one is or is not skidding.
3/8/2015 6:15:46 AM • 2005 Chrysler... • Answered on Mar 08, 2015
0helpful
1answer

When turning on car pushing on gas pedal around 300 rpm inside of car sounds on the passenger side of car a grinding or rubbing noise

That can be a number of things. I just had a car with that noise and it was a broken motor mount. This caused the engine to move when you push the gas pedal, the fan hit the radiator shoud and that was the noise. I can't really diagnose the problem, unless I am there to witness the noise.
2/5/2015 5:05:51 PM • 2005 Chrysler... • Answered on Feb 05, 2015
0helpful
1answer

WHAT Fuse do you change to light the temp. control

usealy thats a bulb in the panel
11/29/2014 1:41:16 AM • 2005 Chrysler... • Answered on Nov 29, 2014
0helpful
1answer

What fuse do I need to change to make my temp light come on; on the dash board any make temp blow

Is this the only light that is out? If so the bulb has failed. You would have to change the bulb. Pop the plastic cover over your instrument cluster, Unscrew the instrument cluster (4 screws) , pull towards yourself .The bulb is behind the temperature gauge. There you will find a holder of the bulb, turn left or right to unscrew remove and change the bulb. I believe it to be 194. When installing bulb wipe clean with cloth and don't touch. Skin oil tends to make for short life. Install bulb and go in reverse till all is together. GOOD LUCK FRIEND.
11/12/2014 3:13:17 PM • 2005 Chrysler... • Answered on Nov 12, 2014
Not finding what you are looking for?
2005 Chrysler Pacifica Touring Logo

76 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Pacifica Chrysler

  • Pacifica Chrysler

Most Popular Question

pacifica steering pulls left car shakes

  • Cars & Trucks
Loading...