20 Most Recent 2006 Chrysler Sebring 2.7 Questions & Answers

You'll need to describe your problem in more detail. What exactly happened, and when?

Try jacking up front of car when bleeding air.

Vacuum leak at intake manifold gasket could do that. Is Check Engine light on? If so, get codes read and report them here. If code P0505, you need an IAC motor.

Check TPS sensor and IAC sensor.

have a compression test done to check for faulty head gasket or cracked head. Check radiator cap is operational and check level of coolant at radiator cap. Possible overheat situation

u need to check that the battery was installed correctly. red cable to positive and black cable to negative post. did u get the same size battery as the old one?

when it comes to ball joints do both upper and lower never just one can come back to bite you in the end

General advice:Radio controls has two plugs:one is behind the switch,the other is on the back of the radio,ceck to be firmly plugged.Most commun :radio in plug is loosed.Cheers,hope u figure it out.Share.

Here's a picture of it,located next to blower motor,2 screws hold it on.Here's where the blower motor is.

if the starter relay is clicking that means the starter is bad .

change the cap

To check slighty pry the bottom edge of your door with your fingernails if it is tight all the way to the bottom it probably is the snap fastners. Make sure to remove the door handle bolts/nuts.Ford F150 Parts

http://www.obd-codes.com/p0441

The belt is slipping or the compressor and/or clutch is bad. If the compressor won't turn freely with the engine off, it may be locked up which will make the belt screech.

there is a level sensor in the fuel tank you need to drop the tank out to change it