2005 Chrysler Sebring Sedan - Answered Questions & Fixed issues

Well the code p0300 is a mis fire code the 315 is I believe a cam timing code which can cause the 300 replace the cam trimming actuator, it should fix ur problem.

PROBLEM IS NOT IN ALTERNATOR PROBLEM IS IN THE WIRING AND RELAY BOX SOME WIRE ARE SHORT

Are the hoses leaking at the radiator or the leaking at the tranny

https://www.manualowl.com/am/Chrysler/2005-Sebring/Manual/529 Locksmith Tonawanda Ny 24 Hour Locksmith 716 848 0099 in Tonawanda Ny

Chrysler Sebring - YouTube

? 5:22 www.youtube.com/watch?v=yitCY5uPlDc

Oct 31, 2013 - Uploaded by 1A Auto Parts http://www.1aauto.com/ In this video, 1A Auto shows you how to remove, replace and install a transmission .

over filled

http://www.helpowl.com/manuals/Jensen/VM9212N/47429

I think it is a fuel problem. Change your fuel filter and then check the fuel pump.

the 2.7L is a V6, to perform a drive cycle you need 1/4 to 3/4 tank of fuel and do not exceed 59 mph for a good 10 to 20 miles and then a key cycle to check if it did not go try again . best when cold start up

possible fuse or dimmer switch

this is limp mode most likely. is there a check engine light or abs light? if so, have code read. MOst likely its a speed sensor.

remove the blower motor and make sure there is no junk like a mouse nest or something in there. other wise the blower cage is loose on the shaft or you need a new blower

the battery may be n.g.

make sure you have power to the pump, if so, sometimes the squirters get clogged

if you battery is good then the starter needs replace or repair

there is a special socket for that, although a regular deep socket would probly work

there is a possibility the sensor is not working properly. this is the o2 sensor after the cat.

they are the same

most likely an inner or outer tie rod. also check the bolts that hold the rack down to make sure its not loose

after you fill with fluid, start engine and turn the steering wheel all the way back and forth a few times, then let it set for a few mins so the air bubbles will settle. then fill with fluid and repeat the process again. that should do it