20 Most Recent 2008 Citroen C-Crosser HDi Questions & Answers

there is a problem in the brake system in that the brakes are dragging and staying on. could be a master cylinder fault, adjustment if drum brakes, seized callipers. Take it to an accredited brake shop and have it fixed.

Radiator fan is controlled by a temperature sensor. If the temp is at the point that the fan should run, it will turn on, whether car is running or not. If the car sat for hours without running And the fan kicked on, I would change the sensor...otherwise its probably doing what it is supposed to do. It also runs all the time when the air conditioner is running.

Anti pollution light, I never heard of a Check engine light being called that.Read on please.

HelloWhen the service engine soon light (Also called the check engine light or engine management light) is turned on this is to alert you to the fact that Powertrain Control Module (computer) has detected a failure somewhere in the systems it controls you may not feel any difference in the way the engine runs, this can be the transmission or the engine or emission system, there are fault codes set in the modules memory for these faults. What needs to happen now is to have the powertrain control module scanned with a special tool called an OBD2 electronic engine control scanner or a OBD2 code reader. Once the code(s) are read then you must perform the diagnostics for each code and make the appropriate repairs based on the findings of the diagnosis that was performed, this is called doing "Pinpoint" testing.

We had this with our grand picasso all the warning lights on then car went into limp mode replaced two lambda sensor as this is what citroen thought it was in the end coolant sensor was leaking up wire back to ecu making all kinds of lights come on as it malfunctioned in the end new ecu cost over thousand pounds.

Setting the date and time on your Citro?n C-Crosser can be done through the vehicle's control panel. Here are the steps: Access the Menu: Turn on the ignition or start the car. On the control panel, press the INFO button to access the "Info" screen. Navigate to Time and Date Settings: Within the "Info" screen, select the "Route" menu. Look for the option related to "Time and date" or similar. Adjust the Time and Date: Use the appropriate buttons (up, down, left, right) to navigate through the settings. Select the minutes, hours, year, month, and day as needed. Adjust the values using the left and right buttons. Press OK to save the changes and return to the menu.

The most likely location for it is up under the front, left wing between the front wheel and the bumper. You might need to take the wheel arch liner out to get to it. If it's not there check the wheel arch on the other side. Another common location is behind the front bumper mounted on the bodywork crossbar between the radiator and the front grille.

These locks don't work like traditional mechanical locks. It's just spinning as the lock and key are designed to do it if a wrong key is used. Original keys can become too worn to engage the mechanism inside it making it spin the same way. Try these basics. Do you have a spare key you could try? Is there a key slot in the passenger side door you could try? Could you get to the driver's seat through the side or rear doors? Have you tried spraying a fine oil into the lock to lubricate it. *NOTE* Do NOT use WD40 as it is not an oil. I would suggest something like GT85 or 3in1 spray.

I have posted an instructional video on how to locate the diagnostic ports and reset your error code. Please note: fault code F40A is recorded when the oil level has not been measured, or when the temperature of the engine coolant is higher than the set threshold. Please be sure to check your fluid levels as low oil or coolant could result in the engine over-heating and burning important gaskets resulting in irreparable damage.

Disconnect your battery! Remove the old wite from the battery supply end to the far end. Replace it in the reverse order connecting the battery supply end last. Reconnect your battery.