20 Most Recent 2009 Ford Edge - Page 2 Questions & Answers

Don't you have any other repair shops in your area. A local independent repair shop an not a chain store type , like pep boys or firestone , monroe muffler an brakes etc..... The switch could be the problem , but without testing that's just a guess . The thing to do would be to use a digital volt meter an test the circuitry into the an out . B+ power and ground . There are videos on youtube , testing electrical stuff on cars . Basic Electricity for Service Techs Ohm law Current Flow Opens Shorts How to Use Multimeter Beginner Crash Course Check out some more videos . You can find wiring diagrams at http://www.bbbind.com/free_tsb.html

OK. What's your problem?

Bad Battery in your remote or bad remote? don-ohio

if you didn't have one installed you don't have one. these are and aftermarket installation.

Dear James, Well, no. It is possible the car has a leak, and the belly pan is catching the leak and collecting it. Perhaps you should take the car somewhere and have a person look underneath with a strong light and see what is going on. You car should have NO gas leak at all, and a little bit of oil is OK, but not much. God bless your efforts.

Try resting computer by taking both battery cables off for about 5 minutes

First make sure the battery is disconnected to avoid blowing out your air bags. Next replace the offending collision sensor, it should be located on the radiator support, you may also need to remove the front bumper cover to gain access. If the vehicle was in a collision and that is the reason it's being replaced, then make sure you also check wiring for any damage as a short can cause the airbags to go off again unexpectedly and cause injury or damage to the vehicle. After replacing the faulty part, clear the code(s) from the BCM.