20 Most Recent 2003 Mazda 323 Questions & Answers

call a lock smith

If you do not have any spark ( petrol engine ) check for distributor cap, rotor arm, ignition module inside the electronic distributor, or any loose wiring connected on distributor or ignition coil or any wire.Also check and the HT Leads.

remove four bolts normally on all four corners remove the plastic cover to reveal the bolts

servo sensor needs replacement

Hi 0.25 mm for inlet and exhaust valves. set it when engine is cold Good Luck

Be sure to check all the fuses with an ohm meter or circuit tester. If no blown fuses,check for power in and out of the electrical connection on the ignition switch. Do the headlights or dome lights work? If so, it is not a battery issue but, an electronic issue. It could be the engine control module, but check all the basics first.

Flat battery coming up. Low voltage

Those Mazda's aren't made to tow,so your not going to find out.

Spray startin fluid in the intake need to get the gas flowing threw all lines and injectors

If you follow the wires to the top of the engine from the distributor, they are under the boots when you remove them. Plugs are about 4-6" down inside.

"Life wire??" I don't know what you mean. Usually, the backup camera will derive its power from the positive lead of your backup lights, so that it only turns on when you're backing up. You can use a standard wire tap to derive positive (+) from either backup light, and use chassis ground for the negative (-) lead of the camera.

Yes, could be fuel-check the fuel pressure with key on.

trade it in quick or fit a manual gearbox this is expensive