20 Most Recent
2005 Mitsubishi Outlander LS - Page 11 Questions & Answers
How to reset oil light/maintenance
this is done with the help of a diagnostic tool called a code reader. The reader connects to the cars computer and you use this co clear and reset error codes. A local mechanic should have one,, simply ask them to do it for it,, Its cheaper than buying your own.
When in drive mode, transmission
auto trans are complex and cud be a # of things-specialy with age and milage--however a shift solenoid may be failin or a relay--also a clutch may be smoked or a problem in the valve body--have u had a drain and fill service--have vehicle scanned for bad codes
I use my cigarette lighter
Hi!!
On the relay box look for the Acc. Socket fuses
#23 -10A and
#25 - 15A. To fix the socket, remove the Center Lower Panel using a flat tool or a butter knive to make the clips on each corner pop out, the socket can be re-tightened, they usually do not get damaged. once fixed, snap the
Center Lower Panel back into the dashboard.
Check the following diagram.
If you need better quality images, please provide an email address to send them to.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.
What part is required to
this code refers to the throttle position sensor. most likely it is a faulty tps sensor. i have replaced a few of these on mitsubishi,s the code refers to low voltage input meaning the computer is seeing to low a signal from the sensor. to replace look on opposite side of throttle shaft from where throttle cable is hooked up will be a sensor held on by two screws.
I noted an oil leak
The play in the turbo is why you have the leak with out rebuild shop tools all you can do is change the turbo (if a lot of oil gets into inlet
system engine can run away and will not stop ((English mechanics
call this drinking its own blood)))
10/24/2010 12:39:18 PM •
Mitsubishi...
•
Answered
on Oct 24, 2010
Mit Outlander 2003....replaced the head
P0340 Camshaft Position Sensor Circuit Malfunction
P0335 Crankshaft Position Sensor A Circuit Malfunction\
Based on the codes you listed I would have to say it appears the Crank Position sensor is either malfunctioning or you accidentally caught the wires between two parts that were bolted together and they shorted out. Double check the Crank Position sensor wiring and make sure you have them connected correctly and don't have a short on any of the wires.
Hi i have a problem
You more than likely have air in the system.Grab another person if you know how to bleed the slave cyl,but only for a hydraulic clutch.If it is a cable clutch,adjust the cable.
I have this
take it nto a trans shop & have a service/ band adjustment done...
Mitsubish pinin - all lights
Possible that the dashboard cluster ground is faulty and the reason why all the lights of the dash are on. the dash is normally triggered bythe park lamp switch and so ther must the + 12 coming tothe lamps on switch on.
Not finding what you are looking for?