20 Most Recent 2011 Nissan Micra 1.2 - Page 4 Questions & Answers

You need to be certain you are entering the correct code in the correct way to avoid being permanently locked out of the radio. Different territories and models have slightly differing radios and the coding sequence can vary slightly. The vehicle literature pack should either contain an audio manual or the details will be found in the vehicle handbook.

Try this site for radio wiring colors. modifiedlife.com

Anyone of the moving parts in the steering can wear and cause this, I would go under the car and have someone turn the wheel and try to isolate the sources of the noise.

Check for bolts at the front of the bottom seat by the floor .

S?fety switch

what is a malfunction light??pulling away from what??? what car???

Located in engine block at top of starter area pending engine size..All crank sensors are located in engine block area at the front or rear of engine...You will need a vehicle lift to safely inspect certain areas....It has a wiring plug connected to it...The sensor presses into block and is mounted with one bolt...

they usually only have one unit in the tank which is a float operated variable resistor

The light operates from the neutral start safety switch on the side of the transmission. Have it checked to see if it's sending power to the bulbs when it's in reverse.

A car needs 4 things to start: A Fully Charged Battery, Air, Fuel and Spark. So tell me what was the last thing you remember the car did before it broke down? I ask cause normally a car gives you a warning before it stops running. Also how long between Tune-Ups?

Yes sometimes a dirty throttle body can cause problems also mass air flow sensor can if it dirty and spark plugs to.

adjustment at handle mechanism, 10mm bolt or nut on cable

the tire pressure shoul be at the passenger door pilar or on the tire wall