20 Most Recent 2005 Nissan Murano SL Questions & Answers

Question edited for clarity and toss in CAPS. Question moved to model category. In the rear doors and under the cargo bed. https://www.nissanparts.cc/v-2005-nissan-murano--se--3-5l-v6-gas/body--sound-system .. .

Could be idler arm, or brake sensor making the ABS come on while you are driving, seized brake caliper, bad wheel bearing, U joints, or rear differential.

You will have to remove your steering wheel to replace this. First disconnect your ground on your battery. Let the car sit for a couple minutes to make sure all charge is out of the wires. On both sides of the steering wheel, there will be to little square covers. Take those off. there will be a torque bolt behind these covers. Remove those. After doing this, your air bag on the steering wheel will be able to be removed. then your ill see a nut in the middle of the steering wheel. Remove this nut. The next step can be done in two ways. one you can get a steering wheel puller to remove the steering wheel, or you can grab a hold of the steering wheel on both sides and shake the steering wheel loose. This will work most of the time but may not. After removing the steering wheel your clock spring will be underneath it. There is either two or four screws holding this on. install in reverse order. When you put your steering wheel back on, there are marks on the rod and the steering wheel you will need to line up to make sure your steering wheel is straight. If you have any more questions, just ask me.

Take it to mechanic you need equipment to set the properly

Hi for what reason you had your throttle body replaced? does the old one had the same problem? if yes, that means you have a wiring problem. if no, that means the throttle body that you fit is faulty. ADD to that, when you replace a throttle body on nissan vehicle, you need to run throttle learning, this should be done by capable diagnostic machine/technician. Good luck

Maybe the unit beeds attention, if the vehicle is recent visit a main dealers garage/service department. You might just want to visit an ICE retailer and have it tested/repaired or replaced

try unlocking it while its open sometimes they get jammed up by trying to close them and the latch will get hung up in the closed position if you take the key and hold it in the unlock position (don't release ) and then try to manuver the metal latching part it will pop loose ,doors are famous for this !

There is no module for air bags . There is a fuse its not something that needs sensors unless their is an impact witch their are sensors for but not a signal module. because its a federial mandate and their several impact points on vehclies.

Remove tail lights the screws are probably inside the trunk

I believe there is no answer to peeling clearcoat. You need to see a custom paint specialist for advice on best options.

there might be 2 you have to check under the hood in the engine compartment or in the car under the drivers side dash or floor as well if you have the owners manual it will show you where and which one is located if you dont then you will have to read the fuse box label to locate it

If not a fuse could be all,LED lights.

YOUR VEHICLE HAS TRANSMISSION PROBLEMS.hERE'S A LINK TO LOOK AT.

you have a blown fuse. make sure the battery is in correctly. the neg- neg the pos to pos.

try this put key in ignition turn to number 2. then press the fob. when the door lock press again to unlock them should work of from there. remeber to replace the battery in the fob first.

Could be day light running module.