20 Most Recent
2006 Peugeot 207 1.6 Questions & Answers
How do I remove the bonnet of my Peugeot 207?
needs 3 people
one to hold the bonnet up and one on each side to undo the hinge bolts and gas struts if used
replacement is reverse with an adjustment before the bolts are properly tightened
about 10 minutes work
Ac compressor relay location
If you suspect low refrigerant you can use paperclip to jumper the low pressure switch momentarily. Relay should be in main fuse block under the hood, I think.
Clutch pedal goes to floor
Hi Stephen, I think the problem is a leakage from either the clutch master or slave cylinder. Open the hood and check the fluid level in the clutch reservoir. If it's empty my suspicion is confirmed. Look for signs of leakage first from the master cylinder, then the pipes and finally the slave cylinder. It's a good idea to replace both cylinders at the same time. To do so requires the following work. Inside the cabin the push rod connecting the pedal to the piston must be disconnected and then under the hood (bonnet) the fluid pipe disconnected followed by removal of the securing bolts. The same operation applies to the slave cylinder. When assembling always connect the pipes before securing the cylinders.Hand tighten the pipe connections, leaving just one final turn for the wrench (spanner). The pipe connectors are easily damaged by cross threading the connectors which results in leakage. Once the clutch operating system has been installed, fill the reservoir and have someone kind keep it full with dot 4 brake fluid. Open the slave cylinder bleed nipple and allow the fluid to flow into a container until the it flows without air bubbles and then close the nipple. Happy driving Regards John
Not finding what you are looking for?