20 Most Recent
2006 Peugeot 407 1.6 Questions & Answers
407 heater resistor
Under the dash lhs next to the heater box. Usually. But then it is French so be prepared.
Why fuel guage is not working
Hi dear,
If the fuel gauge does not work must be verified:
1. gasoline pump gauge wire if it is cut
2. Remove the gasoline pump and check the float arm if it is stuck
3 . Electronic Resistance in the gasoline pump damaged and need to replace
regards
Vehicle smoking
If the oil level is a bit high, a car can smoke. Make sure the oil level is below the "MAX" line.
Hello have alot of oil around injectors done rocker cover seal could it be injector seals
Injectors shouldn't leak oil around their seals. It's a good time to clean the area leaving it spotless and monitor to see where the leak is coming from. It could be the recent seal job was not successfully done. Excessive crank case pressure would force gases out of the engine thru seals and gaskets, a bad pcv (positive crankcase ventilation) system would be the cause or some other internal reason.
Peugeot 407 hdi forum
-Always refer to its manual.
Most car require at 60 to 75 Thousand miles
Good Luck
Mai
Not finding what you are looking for?