20 Most Recent
2005 Suzuki Jimny Classic Questions & Answers
Stuck in 4 wheel drive low
this is not AWD, so what are the tires touching? do tell.
by what indication.?
- just the silly light.
- the lever is stuck
- or all 4 tires spin on ice.? in 2H?
are you on ice. or dirt. if not better read the operators guide,
as that is wrong. if driving on dry pavement. move to dirt or gravel area and shift back to 2H
cured now. next time dont drive on non iced roads in 4wd or 4Lo
or it will bind up. need a suzuki TSB warning you?
have it.
http://www.fixkick.com/part-time-test.html
solution, i think is stop doing that.
the TSB solves the after you messed up .
Valve lifters sound
in park?/neutral, at 0 mph>?
use a stethoscope ($5 tool)?????
and listen to it.
ever do the 60k mile service, no, then now is the time.
called LASH setting. done at ever 60k timing belt change.
all this is listed in the operators guild, lost that?
do the 60k and see what happens.
O1 Suzuki jimny not charging,changed battery and alternator,fuses checked still no joy.
welcome to USA forum the country with ZERO JIMNY !
no books on it either.
My guess is the charge lamp on, what does not charging mean.
- charge lamp on,?
- battery volts, not 13.3 to 15vdc running, idle 800?rpm?
- is charge lamp glowing key on, if fix that now. not running, it must glow or some ALTS will not boot up, called cold excitation current, that some NEED. fix the lamp.
- wiring bad. to alt. or alt casing not grounded.
- or car stalls.?
- or battery goes dead when you sleep or long day at work>?
- try to say what NO CHARGE MEANS? why do you say it.?
- on new USA cars, some the ECU runs the ALT, so, and 2001 is common here, but I cant look for you can I. (no books on JIMNY)
- what engine,, there are many, 658 cc K6A I3 (JB23)
1,298 cc G13BB I4 (JB33)
1,328 cc M13A I4 (JB43)
1,461 cc K9K TD I4 (JB53)
- the engines run there own Alternators, very different.
Side lights at back dill just ever so slightly when the indicator is on
could be a short in circuit somewhere because Daytime running lights don't have to be separate lights - some car manufacturers combine them with the front position lamps (side lights) in which case the daytime running lights will dim when the headlights are turned on.
If daytime running lights are located very close to indicator lights then the DRL on the appropriate side of the vehicle must turn off while the indicator is operating to avoid masking its signal.
What is the emission control system on a suzuki jimny? my emission control light came on and the jeep wont start..how could this be solved?
sorry nat, its no jeep.. (closest match here is Samurai)
moved yah i did.
No year stated, hopeless, for sure.. that...
nor is Jimny sold in USA, and this is a uSA forum.
Means we have no books on Jimny here...for that fact.
forget that lamp CEL?, it glows telling you , PCM has power and as a self test on lamp on all cars.
but the IMMO lamp? that be #1 to see... if fitted. as some are.
what matters only is this.. see how far you can get.?
won't start means nothing unless you say it cranks and don;t start.
starter motor sounds ok, not silent.?
see, we can hear this or guess. and is KEY to the reasons.
all you can do is test fuse.
see if cluster immoblizer light is glowing funny or flashing wrong.
dont crank ,? clean battery lugs, and then charge battery
jumper cable crank it.
cranks ok, check for spark.
if dont know how get tow to shop that does.
How it works the solenoid valve from automatic transmission
no year?
the solenoid can be for many functions,
the old cars has 1 , called the TCC.
clutch lock up,
the ECU sends (or TCM) sends 12vdc to it near 45mph to lockup the main clutch (TC) the solenoid opens, and main line pressure passes through this valve to the Solenoid lock it self, the lock engages and TCC locks up.
later years, they shift all gears this way with 3 or more solenoids.
get the FSM and read the Tranny chapter.
205/70R15 tyre pressure
on pavement , dirt or sand? (ice?)
not stock, ???? key point that. if is, its in the manual and door jamb.
if car is stock and tires are not stock then the body tag for pressure will be wrong. (you did it)
there are 2 ways to do this. if not stock
use the tire engineering tables for weight and tire presssure.
bingo , its a fact each maker of all tires have this table !!!!!
WAY 2: (rubber meet the road , LOL)
or use the tire print test..
under pressure tires, cup
over pressure tires, crown, (RTM)
both cause poor pavement traction, especially on ice.
the tire print trick is with chock/ink/paint on the tread?,
roll car , see prints.?
(see the ink test? paint or chock)
http://www.sensorprod.com/news/white-papers/tcp/
see the contact photos?
see photos. is this clear?
http://www.lexusofpembrokepines.com/tires/tire6.jpg
Not finding what you are looking for?