20 Most Recent
2010 Toyota Corolla 2.0 Questions & Answers
I changed 1 of my valve sensor so i need to no how to reset the tpms light
By operating the tire pressure warning reset switch, the tire pressure warning ECU can be set to issue a warning at an inflation pressure that corresponds to the standard pressure of tires .Therefore, you must set the warning threshold to the proper value in order to comply with the local regulations .Operate the tire pressure warning reset switch only after the inflation pressures of all tires have been adjusted on the vehicle.To initialize the system, press and hold the tire pres- sure warning reset switch for 3 seconds or longer with the ignition switch in the ON position. When the system receives the
initialization signal, the warning light blinks 3 times (1 second on, 1 second off). During initialization, the tire pressure warning valve and transmitter measures the inflation pres sure of the tire, and registers the signals that are transmitted into the tire pressure warning ECU at a frequency of once per minute. The initialization process is completed when signals from all the tires have been received. It takes a few minutes .
Tire size Inflation Front Inflation Rear
P 195/65 R15 89S 30 psi 30 psi
195/65 R15 91H
P 205 /55 R16 89H 32 32 psi
P 215/45 R17 87W
205/55 R16 91V
Valve clearances toyota 7afe engine
Toyota 7A-FE valve clearance (measured cold):
- Inlet: 0.15 to 0.25 mm (0.006 to 0.010")
- Exhaust: 0.25 to 0.35 mm (0.010 to 0.014")
Source: https://workshop-manuals.com/toyota/corolla_sedan_4-door/l4-107.5_1762cc_1.8l_dohc_(7a-fe)/maintenance/tune-up_and_engine_performance_checks/valve_clearance/system_information/specifications/page_815/
It a Toyota corolla nze 2001 with mileage 200k km
As advised by your mechanic, my advise is no different, in the gearbox there are what we term as teeth of different gears and synchronizers...being in such behaviour, your car needs a gearbox overhaul or replacement depending on which will cost you less
How do i remove the gauge cluster of a toyota corolla 1989 1.6 gl 16 valve?
have you removed the steering wheel cowling ? if not do this as may be another couple of screws there, if you have you have to gently wiggle it as far forward as you can so you can get your fingers behind it and release the speedo cable as it is usually this that is holding back these older car dash's
1990 corolla 4afe engine overheating
For many of the 90's and 2000's Toyota various models - Camry, Tacoma, 4 Runners, Corolla, and some other models it is usually caused by temperature sensitive fan switch on the radiator not operating. Electric fan on the radiator should operate when temp above 200 degrees. Less often the control relay 90987-03003 is defective. Check if bubbling in the radiator smells like exhaust. That would indicate a blown head gasket. A jumper wire from your marker light positive to the lower contact in the fan control relay socket will operate your fan when parking lights are on. The larger vehicles with more powerful radiator fans will need a hefty jumper from a headlight positive to avoid overheating the lighting wiring.
Not finding what you are looking for?