20 Most Recent 2004 Nissan Nissan almera tino Questions & Answers

You need a square 8mm socket

How do I adjust the handbrake cable on a Nissan Almere 2004 please

At the back side (rear at the bumber)

NISSAN MICRA ZS what year.???????????????? the whole assmbly or the bulb is bad. any auto body shop can show you or do the latter. the bulb is covered in the operators guide (glove box) of all cars. lost that?

Best going to a nissan forum to ask this Truck SUV Nissan Forum Nissan Trucks Forum

look on hooded vent area( under windshield whippers) sometimes there is a drain line that gets plugged with leave and dirt use a air line blow through and clean out this should do it

Check the condition of your battery, is it fully charged or not by using your Volt meter for a voltage test and it should be more and not less than 12.5 volts, a load tester for testing it load and it should pass the test and a hydrometer for testing the battery specific gravity and it should be in a green column and also check the battery connections.

Confirm the timing marks were aligned properly by manually rotate the crankshaft up until piston number one is on a compression stroke, try to do this twice and make sure that the timing marks should be aligned accordingly with piston number one in top dead centre.

Check your wire diagram it could be IGN bad wire

Is there any other codes? http://www.alldatadiy.com/alldatadiy/DIY~G~C45827~R0~OD~N/0/138181779/138629620/138629625/138629629/34853741/96340231/96340248/176614763/178118043 Try this link.

ECM and TCM are both located under the dashboard, behind the glove box. You must remove the glovebox to access these modules. Remember that any yellow wires or connectors are for the air bags. You should probably refer to a service manual before accessing anything electrical/electronic.

P1715 is code input speed sensor

The switch is inside within the light switch on the left lever. you have to roll it backwards.. Hope this will help