20 Most Recent 2007 Chevrolet Chevrolet Equinox LT - Page 4 Questions & Answers


It can only be power feed. Start at the light work backward till your meter power again. Possibly a broken wire on terminal point.

Chevrolet Cars &... | Answered on Nov 09, 2019


PEOPLE NEED TO KNOW THE EXACT VEHICLE AND WHAT NUTS???

Chevrolet Cars &... | Answered on Nov 05, 2019


On the cover for the fuse/relay panel, there should be a diagram showing the purpose of each fuse/relay. This may also be shown in the owner's manual.

Chevrolet Cars &... | Answered on Nov 01, 2019


A company called Helm they print manuals

Chevrolet Cars &... | Answered on Oct 30, 2019


1. ENGINE COMPARTMENT RELAY AND FUSE BLOCK


26124857-2d4op3gqpglrxo3upjjpq0jg-1-0.png

Chevrolet Cars &... | Answered on Oct 30, 2019


You've taken care of some really good things to check. A sensor would be my bet too. However, you could be dealing with a set of loose connectors, most likely a wiring harness when they changed out your transmission; I'd look where the engine-transmission join, or anyplace they would have had to disconnect wires to get to the transmission. They could have been loosely connected, and have come further apart. Perhaps if you find some loose connections, zip tie it or rubber band it together if the connector is cracked or broken.

Chevrolet Cars &... | Answered on Oct 28, 2019


I'm confused as to why you would want to do this? I can not fathom a logical reason for needing a heater in any radiator hose. If your have a freezing issue, have someone check your antifreeze. incorrect water to antifreeze ratio such as having too much water, or worse, only water in the cooling system will result in a frozen hose, especially the lower one, as it tends to be more exposed to the elements from under the vehicle.

Chevrolet Cars &... | Answered on Oct 28, 2019


The idler arm is sold as a unit with new bushings on each end. To remove it you will need to remove the castle nut from the tie rod and then using a splitting fork separate the unit from the tie rod. Then remove the bolts holding it onto the frame.

Chevrolet Cars &... | Answered on Oct 28, 2019


if this is the 6.0L engine it is on the top rear driver's side of the engine block. between the intake and the firewall

Chevrolet Cars &... | Answered on Oct 26, 2019


As far as I know, the engines are basically identical on the outside. The problem with engine swapping on these computer-controlled cars is, you also have to change the computer since each engine has a computer programmed for that particular engine. This often requires not only changing the computer but also changing wiring harnesses to match. In short, the engines will most likely swap but it is the computer that makes the difference.

Chevrolet Cars &... | Answered on Oct 21, 2019


Did you happen to find small pieces of plastic in the driver's floorboard? If so you unwittingly found the problem. The brake light switch is mounted so its plunger presses against a small plastic insert. The insert is pushed into a hole in the break pedal arm. When the brake is not depressed it rests the the upmost position so when the insert (when intact and unbroken) does the pushing up against the brake light switch plunger. Check the condition of the insert in the brake pedal arm and replace if necessary.

Chevrolet Cars &... | Answered on Oct 20, 2019


It will be ok to drive but it would have put the geometry out on the steering which will cause tyre wear.

Chevrolet Cars &... | Answered on Oct 19, 2019


Vacuum pump won't prevent it from starting but there are many many other issues that will cause this problem. You're probably going to need to take this to an expert in a shop that has a high quality bi-direction scan tool and the the diesel experience to get it to run again.

Chevrolet Cars &... | Answered on Oct 15, 2019


I would contact the rebuilder and ask him for guidance. You'll need to know what service codes it's setting as it tries to work. It's possible there is a problem in the transmission - rebuilt or not- or there may not have been a problem with the transmission at all and there is a controller or wiring issue.

Chevrolet Cars &... | Answered on Oct 15, 2019


try moving by hand and or removing and lubing

Chevrolet Cars &... | Answered on Oct 12, 2019


Sure sounds like piston damage to me from using the wrong plugs.

Chevrolet Cars &... | Answered on Oct 10, 2019

Not finding what you are looking for?
2007 Chevrolet Chevrolet Equinox LT Logo

45 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Chevrolet Cars & Trucks

  • Chevrolet Cars & Trucks

Most Popular Question

replace abs pump 2004 chevy silverado

  • Cars & Trucks
Loading...