20 Most Recent
2007 Chevrolet Chevrolet Impala LS Questions & Answers
Windshield washer not spraying
dont follow the lines ,first try this .umplug the line from the head sprayers,make sure you have fluid in the reservoir turn on the washer motor you'll see the fluid ,that means the head sprayersare pluged clean them plug back the line hose and enjoy good luck.
Heater and air condioning switch keeps making
The noise is one of the actuators that moves the air flow doors into different positions. Common problem. When the noise happens, move the temp. control from cold to warm. If the noise goes away, it is the temp. actuator. Or, press the recirculation button to go from fresh air to recirc. If the noise goes away, it is the recirc. actuator. Or, change the mode from vent to heat. Could be the mode actuator. Usually the temp actuator acts up.
Recently purchased a 2007 Chevy Impala LS. All
Check the fuse first and then check the wiring coming from the taped off one to see if it has power. Then check the harness to see if they are connected to the same power source, which may be the missing one.
Hi how to set a timing belt tensioner pulley when replacing 2011 Chevrolet aveo
Tensioner pulleys are designed to be 'Self Adjusting'. These pulleys are on spring loaded arms so they automatically push against the belt keeping it tight. You use a socket or a spanner to swing the pulley arm back against this spring.
*Note* This is a powerful spring so BE CAREFUL when your working on it!
A lot of these tensioners have two small holes to help with installing a belt. When you swing the tensioner arm back these two holes line up with each other. You can then slide a hex key, or something similar, through both holes and it holds the arm back giving you space to get the belt on.
*Caution* When your ready to release the tensioner DO NOT just pull the hex key out!! With the socket or spanner you used to swing the tensioner arm back push the arm against the spring again, carefully pull the allen key out then Carefully release the pressure on the spring so the pulley sits correctly and tensions the belt.
Not finding what you are looking for?