20 Most Recent
2007 Nissan Versa 1.8 Sl Hatchback Questions & Answers
Where is the slave cylinder located on 2009 nissan versa 1.8 sedan
Presumably the slave cylinder you seek is the clutch slave cylinder?
If the clutch is hydraulically operated and the slave cylinder and operating lever/linkage isn't visible, the cylinder could be a coaxial type mounted inside the clutch housing.
Following the hydraulic pipe/hose should provide a clue...
2007 Nissan Versa gear shift locked in Park.
There is a switch under your break padal, which is responsible for tail lights and gear lock. if that switch is working fine and your tail lights are working fine then check the electronic lock of gear which is under the cover of gear.
I have a Nissan 2007
I can understand your problem. You can easily get the solution of your problem at the given link
http://toolsnyou.com/ .
I was also facing a problem like this, this site helps me a lot by giving the solution of my problem.
How do i know head gasket damage
the only way is to have a head gasket test done on the car. you can pull the plugs to see if there is coolant in the cylinders or if the spark plug tip is white as this is an indication of a possible head gasket. has your car been overheating. it could be a thermostat and the engine got too hot and stopped. it could have a coolant leak somewhere as well and the coolant ran out. just some things to check.
How to replace exterior door handle on 2007 Versa.
You need a Torx head screwdriver T25. Open the door and on the side of the door is a small black grommet, remove grommet, inside is the torx screw you need to loosen for the lock mechanism to move. you dont need to remove the screw just loosen enough to move the lock assembly around. Once loose enough, install the door handle and tighten lock assembly back and put grommet back.
Here is a picture if you need a bit of visual clues.
http://img266.imageshack.us/img266/1218/versadoorhandlefix.jpg
How to change a headlight on nissan versa 2007
How to change a headlight on Nissan Versa 2007. Open the hood, pull the power cable off of the headlight. Peel off the large black rubber cover. There is a metal clip you must push in and then out to unclip. The bulb will then slide out for replacement.
Not finding what you are looking for?