20 Most Recent 2007 Dodge Ram Truck Questions & Answers


The ignition key is not programmed to match that vehicle. A dealer may be your only option.

2007 Dodge Ram... | Answered on Sep 19, 2019


hi,try to lock and unlock your vehicle with your remote key,park light and running light is activate by alarm system,ty

2007 Dodge Ram... | Answered on May 01, 2019


Intervention Regeneration Strategy - EVIC
Message Process Flow (Catalyst Full Message)
(6.7L Diesel Engines Only)

Your new Cummins 6.7L diesel meets all EPA Heavy
Duty Diesel Engine Emissions Standards, resulting in the
lowest emitting diesel engine ever produced.
To achieve these emission standards your vehicle is
equipped with state of the art engine and exhaust system.
The engine and exhaust aftertreatment system work
together to achieve the EPA Heavy Duty Diesel Engine
Emissions Standards. These systems are seamlessly integrated
into your vehicle and managed by the Cummins
6.7L engine Powertrain Control Module (PCM). The PCM
manages engine combustion to allow the exhaust system's
catalyst to trap and burn Particulate Matter (PM)
pollutants, with no input or interaction on your part.
Additionally, the overhead console in your vehicle has
the ability to alert you to additional maintenance required
on your truck or engine. Refer to the following
messages that may be displayed on your Electronic
Vehicle Information Center (EVIC):

WARNING!
A hot exhaust system can start a fire if you park over
materials that can burn. Such materials might be
grass or leaves coming into contact with your exhaust
system. Do not park or operate your vehicle in areas
where your exhaust system can contact anything that
can burn.

Perform Service
The 6.7L Cummins engine utilizes a Closed Crankcase
Ventilation (CCV) system, EGR Valve and a EGR Cooler.
This system filters and recycles gasses produced in the
crankcase during the normal combustion process. Perform
Service will be displayed on the overhead console of
your vehicle if the CCV filter, EGR Valve and EGR Cooler
is due for required maintenance. The CCV filter is located
on the top of the engine valve cover. For additional
information, see your local authorized dealer.
Catalyst Full See Owner Manual
Catalyst Full See Owner Manual will be displayed on the
overhead console of your vehicle if the exhaust particulate
filter reaches 80% of its maximum storage capacity.
Under conditions of exclusive short duration and low
speed driving cycles, your Cummins engine and exhaust
aftertreatment system may never reach the conditions
required to remove the trapped PM, if this occurs Catalyst
Full See Owner Manual will be displayed on the
overhead console in your vehicle. If this message is
displayed you will hear one chime to assist in alerting
you of this condition.
Catalyst Stat::::::::::80%
Catalyst Stat::::::::::80% will replace the message Catalyst
Full See Owner Manual after it is displayed for one
minute. The engine Powertrain Control Module (PCM)
will continue to monitor the amount of particulate matter
trapped in the particulate filter. This message indicates
the percentage of the particulate filter capacity that has
been used.

By simply driving your vehicle at highway speeds for as
little as 45 minutes you can remedy the condition in the
particulate filter system and allow your Cummins engine
and exhaust Aftertreatment system to remove the
trapped PM and restore the system to normal operating
condition.
Catalyst Stat:::::::::::80%, 90%, 99%
Catalyst Stat:::::::::::80%, 90%, 99% If you are unable to
drive your vehicle under these conditions for an extended
period of time after the initial warning notification,
the Engine PCM will continue to monitor the
particulate filter and will display the progression of
particulate filter usage (80, 90, 99%) on the EVIC message
center.

CATALYST FULL SERVICE REQD
If the particulate filter reaches 99% of it's capacity the
overhead console in your vehicle will chime twice and
display the message CATALYST FULL SERVICE REQD.
At this point the engine PCM will register a fault code,
the instrument panel will display a MIL light and the
engine PCM will derate the truck reducing its horsepower
and torque output.
The PCM derates the engine in order to limit the likelihood
of permanent damage to the aftertreatment system.
If this condition is not corrected and a dealer service is
not performed, extensive exhaust aftertreatment damage
can occur. In order to correct this condition it will be
necessary to have the truck serviced by your local
authorized dealer.

2007 Dodge Ram... | Answered on Feb 09, 2019


indicates an ambient air temp sensor or BARO sensor problem
run the fault codes
the ECM tunes the engine every 60 seconds from reports for sensors so the old fashioned tune up is not longer cost effective
better to have the fault codes read on a regular basis
an occasional can of quality injector cleaner in the tank is a good investment

2007 Dodge Ram... | Answered on Jan 31, 2018


Unless I'm mistaken, there is no fuse dedicated to the trailer lights - they're wired directly to the matching truck lights - the running lights & taillights should be wired directly to your truck's taillights.

Check your trailer wiring from the truck plug all the way back. I've seen lots of poor connections in the truck plug, as well as any of those squeeze splices you might have in your trailer. Look also at the ground wiring for your running lights.

2007 Dodge Ram... | Answered on Sep 24, 2017


Check the obvious - fluid level up to par? If so go back to dealer (unfortunately) since their fix was not permanent.

2007 Dodge Ram... | Answered on Aug 22, 2017


check the pump in clutch pedal for loss of pressure

2007 Dodge Ram... | Answered on Jul 09, 2017


the bushes on the motor have springs at certain temperatures the springs will shrink, can be that the bushes are near to the end of their life. when it warms up a bit the springs go back to normal and contact.

2007 Dodge Ram... | Answered on Jun 09, 2017


You need a new blower motor relay. Have to replace them all the time. It will eventually just burn itself out, they continually short out huge chrysler issue for years.

2007 Dodge Ram... | Answered on Dec 31, 2016


-Fuel leak -Fuel filter -Transfer pump flow -High pressure fuel pump -Leaking fuel injectors or connectors -Leaking pressure limiting valve -Fuel control actuator -Fuel pressure sensor -Restriction in fuel return lines -Cascade overflow valve -Air in the fuel system.

Read more: http://www.autocodes.com/p1011_dodge.html

2007 Dodge Ram... | Answered on Nov 05, 2016


P0522 code means the sensor is indicating too low of an oil pressure value due to faulty sensor, low oil, or sensor circuit

2007 Dodge Ram... | Answered on Nov 05, 2016


Evaporative emissions systems test for a leak in the fuel tank and associated hoses. To perform the test, the computer pulls a vacuum and checks to see if the vacuum holds. Each car maker uses a different techniques to check, but most often it's some type of fuel tank pressure sensor.

2007 Dodge Ram... | Answered on Nov 05, 2016


strange as it may sound, transmissions do not shift into overdrive to pass
they down shift a ratio to get extra torque from the motor and will stay down shifted until the vacuum actuator shifts it back and only then when the VSS reports to the TCM that a ratio change up is needed will the overdrive click in
If you cannot get OD under any circumstances run the fault codes and check for a problem overdrive servo/ solenoid , TCM unit

2007 Dodge Ram... | Answered on Apr 25, 2016


look for a vacuum leak in the hose to the actuator
run the fault codes and look for a problem servo/ solenoid

2007 Dodge Ram... | Answered on Apr 17, 2016


-Possibly bad injector or bad plug wire.
-Lets check the resistance of the injector first. (Need to follow
its repair manual. in Ohm) Is it's not within specification then
replace it.
-If it's good than check the plug wire. Possibly damage or ground some where between spark plugs and coil.

Good Luck

Mai

2007 Dodge Ram... | Answered on Jan 07, 2016

Not finding what you are looking for?
2007 Dodge Ram Truck Logo

640 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Dodge Ram
1999 Dodge Ram

1,750 Questions

1994 Dodge Ram
1994 Dodge Ram

192 Questions

2004 Dodge Ram
2004 Dodge Ram

169 Questions

1998 Dodge Ram
1998 Dodge Ram

139 Questions

1990 Dodge Ram
1990 Dodge Ram

113 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ram Dodge

  • Ram Dodge

Most Popular Question

causes misfire number 1 4 cylnders

  • Cars & Trucks
Loading...