20 Most Recent 2007 Ford Ranger FX4 Off-Road Questions & Answers


Sounds like the physical movement of the linkage is pulling or rubbing the harness. Get up under the dash and see how the harness is located.

2007 Ford Ranger... | Answered on Nov 05, 2015


You have a short to ground in the park light circuit..best have a mechanic look at it because its possible the trailer wiring was faulty and shorted out the Smart Junction Box (SJB)...the park lamp relay is controlled by it and the relay is built into the SJB

2007 Ford Ranger... | Answered on Apr 14, 2015


The differential cover has to be removed to drain the oil from the differential. The cluster gear pin has to be taken out to get to the C-clips that hold the axles in. Try to position the carrier assembly so the retaining bolt to the cluster gear pin is on the top near the back of the differential. Remove the retaining bolt and the pin should slide right out. Take care not to rotate the the ring gear because the cluster gears will fall out and they are a little hard to get back in. Reverse this procedure to put it all back together. I hope this is helpful. Good luck.

2007 Ford Ranger... | Answered on Dec 14, 2014


You can cut it off or pull on the
belt tensioner with the correct
size long ratchet

Make a drawing of the belt & pulley's
first or get a pic on the internet

May be a small sticker under the hood

2007 Ford Ranger... | Answered on Jul 30, 2014


Obtain a manual ( good with shop one ).

2007 Ford Ranger... | Answered on Jul 27, 2014


what about it? we're not mind readers

2007 Ford Ranger... | Answered on Jul 22, 2014


To Whom It May Concern,

Enclosed is a link to a .pdf formatted 2007 PJ Ranger Wiring Diagrams Manual. Perhaps this can steer you in the right direction. http://the.internetissrs.biz/ranger/Volume%203/Wiring%20Diagrams/Wiring%20Diagrams%20Manual.pdf

2007 Ford Ranger... | Answered on Jun 25, 2014


There is not a P0006 code recheck codes or bad ecm.

2007 Ford Ranger... | Answered on May 26, 2014


It could be your U joint on the axle drive.

2007 Ford Ranger... | Answered on Feb 06, 2014


Sometimes limited driving can affect the front brake pads and rotors due to corrosion, and dirt...inspect the pads for being worn unevenly...and the rotors for warping...the rotors would also cause the steering wheel to shake when applying the brakes...A small fix for a nice low mileage Ranger:) Hope this helps.

2007 Ford Ranger... | Answered on Jan 27, 2014

Not finding what you are looking for?
2007 Ford Ranger FX4 Off-Road Logo

147 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ranger Ford

  • Ranger Ford

Most Popular Question

park lights keep blowing fuses

  • Cars & Trucks
Loading...