2007 Nissan Sentra 2.0 SL Sedan - Answered Questions & Fixed issues
How do i get my
Folow these steps to make the check engine light disappear:
1. Put the key in and switch it to the ON position, but don't go all the way - the car should not start
2. Wait for three seconds then push the accelerator five times in five seconds or less
3. Remove your foot from the gas and wait for seven seconds
4. Press on the accelerator and keep it pressed for 10 seconds - the SES light will illuminate and start blinking
5. Release your foot from gas
6. Move the key to the Off position and crank up the car.
3/30/2020 9:47:59 PM •
2007 Nissan...
•
Answered
on Mar 30, 2020
•
8,816 views
I have a 2007 Nissan
I have a couple of thoughts apart from how strange it is Nissan only wants to repair cars that are under warranty. It is a wonder they have any customers at all.
It is normal for there to be a momentary change in engine note/speed when pressing the brake pedal but the change should not be sustained for two reasons.
Firstly pressing the brake allows a small amount of air into the engine intake via the brake booster but if it continues it could mean the booster has an air leak.
Secondly the engine management system is programmed to maintain a certain idle speed regardless of temperature or what load is applied by the alternator, power steering or air con. Perhaps there is a fault with the idle air system.
It isn't unusual for cars of a certain age to be reluctant to start sometimes but mostly opening the throttle part way before switching on and cranking the engine seems to overcome the problem.
5/30/2017 12:05:02 AM •
2007 Nissan...
•
Answered
on May 30, 2017
•
135 views
Turning the heat on makes lot of noise
If the blower motor is noisy, the bearing may be getting bad inside the blower. This will require replacement of the blower motor unit. In some cases, foreign objects can fall into the motor casing assembly also making a noise. The motor will need to be removed for inspection
1/14/2016 4:03:03 PM •
2007 Nissan...
•
Answered
on Jan 14, 2016
•
315 views
How to replace a serpentine belt on a nissan 2007 2.5 s altima
Video Tutorial: https://youtu.be/h4qGOJ5PpSw The easiest way to replace serpentine \ drive V belt on 2007-2012 Nissan Altima 2.5L 4 cylinders engine: - remove front wheel on passenger side - remove plastic splash cover - user 14mm offset wrench to turn belt auto-tensioner in clockwise direction - block auto-tensioner from moving using locking mechanism right above the auto-tensioner pulley - slide the belt off the smooth non-grooved water pump pulley first and then take the belt completely out - when installing a new serpentine belt, first hook it onto all pulleys except for water pump pulley. Hook it onto the water pump pulley last- make sure the new belt is hooked up properly onto all of the pulleys - unlock the auto-tensionerOriginal OEM Part #:
Amazon com OEM 11720 JA00B Nissan Altima Serpentine Belt Follow this diagram to route the new belt on 2.5L engine:
11/14/2015 3:54:00 AM •
2007 Nissan...
•
Answered
on Nov 14, 2015
•
7,198 views
Not finding what you are looking for?