20 Most Recent 2007 Chevrolet Silverado Classic SS New Cars Questions & Answers


Try checking the basics first. Get a good close look at all the connections to see if they're corroded or dirty. Next, where you can follow the wires from end to end to look for nips, cuts and breaks. Check inside the head lamp and check for condensation. There is a relay in the circuit as well which switches from low to high beam. Get this checked as well. Might be worth just replacing it as they aren't that expensive.

2007 Chevrolet... | Answered on Jan 12, 2018


Most vehicles use a twin wiring system. The idea is if one side fails then you still have some rear light.
Usually there are two fuses, one for each side. Check for power at the feed wire and work backwards towards the switch.
Your indicators use a different wiring system.

2007 Chevrolet... | Answered on Jun 03, 2017


Just had this happen today to my 2007 silverado heat on the right side cold air on the left side. After engine was off 15 minutes and restarted heat was on both sides. I'm guessing a relay failed to open door to allow the heat to flow thus blowing cold air.will monitor diligently for a while.

2007 Chevrolet... | Answered on Oct 02, 2016


Go on line to a company called HELM .So its Helm .com
They print the factory manuals for most of the big boys .with a Chevy you might need 2 but their 50 bucks a pop and you will be able to look up and thing about your vehicle and never to ask anyone again .

2007 Chevrolet... | Answered on Sep 11, 2016


Go to autozone website and make a free account, pun in the year, make and model and look for the free repair guides and the electrical systems. If they don't have it you can use the link to ALLDATA but that is not free.

2007 Chevrolet... | Answered on Sep 09, 2016


gee they do that but without any thing specific we can not help

2007 Chevrolet... | Answered on Apr 25, 2015


Requirements

The theft lock radio must be in "LOC" mode.

Procedure:

1. Turn the ignition ON (The radio should display "LOC")
2. Hold down the Radio Presets 2 and 3 buttons for six seconds
3. The radio display changes from LOC to a three-digit number. Write this number down. You now have fifteen seconds to complete the next step.
4. Press the AM/FM button
5. The radio display changes to another three-digit number. Write this number to the right of the first one.
6. You now have a six-digit number, the first three digits are from STEP 03 and the last three digits are form STEP 05
7. Call 1-800-537-5140
8. Press 1 then # (pound). You'll hear "Invalid Code, try again"
9. Press 139010 or 106010 or 206010 or 202107 then # (pound). You will be asked to enter your four or six digit code followed by *
10. Enter the number from STEP 6 then *
11. Listen to the four-digit number and write it down. It will be repeated twice
12. Turn the ignition ON (The radio displays LOC)
13. Use the MN and HR buttons to enter the code from STEP 11
14. Press the AM/FM button. The radio display changes to "SEC". Your radio is now "un-locked" and usable.

2007 Chevrolet... | Answered on Jun 08, 2014


Front brake rotors are warped, time to do a brakes job, make sure calipers float on pins and that you replace rotors, aftermarket are cheaper than G.M. but hold up just as well, change pads and lube the slides in calipers

2007 Chevrolet... | Answered on Mar 15, 2013


I am not sure if this will help but try locking the doors without the remote and then use the door key to unlock the door and start the truck this is just an idea but it worked on my daughters car

2007 Chevrolet... | Answered on Sep 20, 2011


firat of all check and make sure you have a real good ground or otherwise you will lose current to another wire and this can short out and cause the lights to malfunction.

White: Ground
Brown: Running
Yellow: LT and Stop
Green: RT and Stop

This is the wiring code for the 4 wire trailers and
Wire a round seven-pin hitch, typically sold without a wiring harness, to the vehicle observing the following color codes: Run a white 10-gauge wire between ground and terminal one, run the blue 12-gauge wire between the electric brake controller and terminal two, the brown 14-gauge wire between the taillights and terminal three, the black 10-gauge wire between the permanently live 12-volt supply and terminal four, the yellow 14-gauge wire between the left turn/brake light and terminal five, the green 14-gauge wire between the right turn/brake light and terminal six and the purple 14-gauge wire between the backup light and terminal seven (in the center).

2007 Chevrolet... | Answered on Feb 18, 2011


go into the DIC on the dash and enable remote start in opions.

2007 Chevrolet... | Answered on Jan 29, 2011


the light is only coming on when the pcm is detecting the problem. in other words, your problem is not acting up all of the time. needs to be diagnosed and repaired though, as these problems don't heal up by themselves , and tend to get worse. all silverados do not have remote start. that is an add on.

2007 Chevrolet... | Answered on Dec 21, 2010


The following steps must be completed before using the symptom tables:

Review the system operation in order to familiarize yourself with the system functions. Refer to Horns System Description and Operation.

Visual/Physical Inspection
  • Inspect for aftermarket devices (Alarm System if applicable) which could affect the operation of the horn system.
  • Inspect the easily accessible or visible system components for obvious damage or conditions which could cause the symptom.
  • Perform the following if a horn buzzes or has a harsh tone:
  • Inspect for debris in the joint where the horn fastens to the vehicle.
  • Test the torque of the horn mounting hardware. The horn mounting hardware should be tightened to a torque of (7 lb ft) .
Intermittent
Faulty electrical connections or wiring may be the cause of intermittent conditions.

Symptom List
Refer to a symptom diagnostic procedure from the following list in order to diagnose the symptom:
  • Horns Always On


HORNS ALWAYS ON


TEST DESCRIPTION
dak408_4.gif
The number below refers to the step number on the diagnostic table.
  1. This step tests if ground is constantly being applied to the horn relay.
If you are unable to preform checks your self you can pull the horn fuse/relay and take it to a mechanical shop for diagnoses
the under hood fuse box diagram is below .. pull number 37 Horn relay

dak408_5.gif

Good Luck hope this helps

2007 Chevrolet... | Answered on Nov 05, 2010

Not finding what you are looking for?
2007 Chevrolet Silverado Classic SS New Cars Logo

63 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Silverado Chevrolet

  • Silverado Chevrolet

Most Popular Question

car stereo in 2007 chevy silverado says

  • Cars & Trucks
Loading...