20 Most Recent
2008 Chevrolet Silverado 1500 2WD - Page 3 Questions & Answers
Troubleshooting guide
The clicking is the safety switch connected to the Brake pedal that allows u to move the shifter to another gear, like Drive or reverse. This is normal ...My HHR had the same clicking sound when pressing the brake pedal before putting the Vehicle in gear.
2008 Silverado 5.3L V-8
have found this press release hope it reassures you
TSB 06-06-05-001C
"Some customers may comment in a change in the exhaust note or tone when an Active Fuel Management System equipped engine is in 3 or 4 cylinder mode. Some drivers may also notice a very slight vibration in either the accelerator pedal, floor pan, and/or the steering wheel. This is a normal condition for Active Fuel Management System equipped vehicles and no repairs should be attempted."
Customer Information on Active Fuel Management
When the Active Fuel Management System is enabled, physical changes take place within the engine that allow it to run as a 3 or 4 cylinder motor with accompanying additional fuel savings. The change in exhaust tone is expected as all sound from the exhaust is the result of combustion in the engine. The ability to perceive these changes in sound are kept to very minimal levels as the Active Fuel Management System is only activated during a steady state/near steady state driving or during coast down. In both of these situations, the load on the engine is minimal and general exhaust volume (sound) is low. You may give a copy of this bulletin to your customer
Where are the fuses for Onstar, satellite radio
Comments from the dealership, the fuse location
for the Onstar system is located as follows: Drivers-side
instrument panel fuse block, exposed on the left edge of the panel when
the drivers door is open. Pull the fuse labeled: #22, a 10A fuse. The
label in the owners manual calls it the "Driver Information Center
(DIC)". This will disable the ONSTAR system.
Leave to GM
to move the fuse locations around, this used to be under the hood and
it was called the INFO fuse and it was a 15a fuse.
And yes....It does **** that
they moved it from the '07s,on mine its a 15amp fuse under the hood
marked 'INFOTNMT" like you said.
Po449 and455 code what is this
Possible loose gas cap. Tighten cap and disconnect negative battery cable for about 15 min and reconnect to clear error.
Not finding what you are looking for?