2008 Chevrolet Silverado 1500 2WD - Page 3 - Answered Questions & Fixed issues

yes its the break senor that detects ur use of the relase lever when u press on the break it enable the sensor to relay the message to the brain

Check the fuse labeled CIGAR in underhood fuse box

plugged in backwards

switch may need to be adjusted by loosening the bolts on the mounting plate it is adjustable up or down.....check brake safty switch on pedal up under dash

i think it is of turbocharger underboost or overboost but not sure

Need more information. Does the car start normally with a key? Is there a switch for a mechanic to disable the remote start while working on it (some units have a toggle switch)

all you can do @ this time is to drop the pan, drain the fluid, clean the pan, magnet, etc., install new gasket & filter, refill w/ the correct trans fluid, donot overfill !!!!!!!!!!!!! check for loose shift rods, adjust as required, check the lines for leaks, maybe replace neutral safety switch, see if it improved or fixed your issue ! other than that, you may need a rebuild ?????? torque converter & or pump could be ready to go ???? inside trans . have a trans shop check it out, at least thats free !good luck

My advice is never go to any dealerDo you not go to local shops as wellTellinmg

Use the codes you get to diagnoseSame as any OBD2 System problem

Code 1133 is when the O2 sensor in front of the catalytic converter on bank one does not switch back and forth between rich and lean.The problem could be a faulty sensor or something with the fuel mixture. The sensor would need to be tested.

My first guess would be the line is frozen. Can you unplug the line at the pump and see if fluid will come out of the pump ?

No idea to be honest ,this is the sort of job i need my head under the bonnet and all i can suggest is to call a local mechanic to have a diagnosis ,try the spare key first though in case the chip has dropped out of the key or its been de-magnatised by a mobile phone in the same pocket or stood on top of a microwave

should be behind the glove box

check trans fluid level/color. trans may have old/bad fluid in it and may need to be flushed and new filter installed.

P0449 Evaporative Emission Control System Vent Valve/Solenoid Circuit---------OBD2 car code scanner

could be coolant temp. switch

Here is the best picture i could gather showing the brake pedal switch you are inquiring about, i hope this assists you in removing this clip, i know they are not easy to remove, they are on there pretty tight and for good reason.

Have the computer checked for trouble codes to continue troubleshooting the problem.

check for any gear box mountings or engie mounts broken. ur any exhaust mounts as well.

Driver Seat Module Fuse?