2008 Chevrolet Silverado 1500 2WD - Page 8 - Answered Questions & Fixed issues
2004 chevy silverado 1500 4.8l pulling the motor there is a cross bar underneath the motor does it have to come off?
No, Motor comes out the top. Remove hood (With a friend you trust) remove all water hoses from engine, remove wiring from top of engine to fuse box on fender (Be careful if clips are a bit stuck), Undo Exhaust at Manifold / Pipe joint ( This will be a challenge, WD-40 and heat will help),
undo transmission bolts ( Support Trans ) then remove torque converter bolts through Stainless access port, Undo Motor mounts, Chain with large bolts bolted into accessory brackets lift slowly in case you missed anything like Ground wires (Be careful with these as they can cause weird problems later in life) Go Slow, Find a good buddy that has done this before buy him a few beers Not an 18 pack!
12/26/2018 8:36:54 PM •
Chevrolet...
•
Answered
on Dec 26, 2018
•
51 views
My service engine light is
602-909-6450 Message
collisionrepairadvice.com
Mechanical Repairs in your area. Diy's, collision repair advice, Mechanical, Technical, insurance, What you should know! How to save money on repairs, recalls, service bulletins, 40-60% off Mechanical repairs in your area. Dentless Repairs in your area. Paint repairs in your area at better rates. Come check it out
10/8/2018 10:03:21 PM •
Chevrolet...
•
Answered
on Oct 08, 2018
•
485 views
1997 chevy silverado pu 4x4
ENG 1 - 20 amp fuse - under hood fuse Box . This fuse powers the O2 sensors heater circuits , Emission - purge an vent solenoids , mass air flow sensor , camshaft position sensor an A.I.R. intake recirculation relay - if your vehicle has it , L31 only
I would look for wires for o2 sensor melted on a exhaust pipe or manifold . Isn't your check engine light on ?
9/30/2018 4:59:31 AM •
Chevrolet...
•
Answered
on Sep 30, 2018
•
1,410 views
When replacing the transmission on a 2002 1500 silverado, how many quarts of fluid are used?
The best solution you'll get from books at
www.reliable-store.com
These are books containing info on repair, service, troubleshooting , parts info, assembling dissemble, removal, error/fault codes, wirin g diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc
6/28/2018 7:07:47 AM •
Chevrolet...
•
Answered
on Jun 28, 2018
•
87 views
1994 chevy k1500 4x4
Speed sensor is most likely goin or gone out. It is located on the drivers side of the transmission tailshaft. Speed information runs through the cruise control and the computer to the speedometer.
3/5/2018 9:26:48 PM •
Chevrolet...
•
Answered
on Mar 05, 2018
•
2,582 views
Signs blown head gasket
Sounds like a bad head gasket, leaking from a water jacket into an exhaust port.
3/2/2018 6:37:45 PM •
Chevrolet...
•
Answered
on Mar 02, 2018
•
64 views
2001 Chevy Silverado, 5.3 had only 5 pounds oil
remove the pump and the cover off the gears
fill the spaces of the gear teeth with Vaseline or clean grease
this is priming the pump so that a vacuum is created to suck up the oil
new pumps will not be primed
the grease /Vaseline will dissolve in the oil and will not cause any problems
1/28/2018 5:16:04 AM •
Chevrolet...
•
Answered
on Jan 28, 2018
•
124 views
If I continue to recieve a code 22 on a 1992 Chevy
Did you check wiring circuit at tps? The gray wire is 5 volt ref, the blue wire is signal and the black wire is ground. Usually you can use digital multimeter on signal wire with key on, you don't need to start it. Move the throttle by hand, the voltage reading should move up and down, smoothly.
1/15/2018 7:11:58 PM •
Chevrolet...
•
Answered
on Jan 15, 2018
•
203 views
I have a 1997 Chevy
I would make sure the ground is ok. You may have disturbed it while changing your part out
1/14/2018 10:26:50 PM •
Chevrolet...
•
Answered
on Jan 14, 2018
•
79 views
Not finding what you are looking for?