20 Most Recent
2008 Land Rover Range Rover Questions & Answers
How to fix fault p0021 and engine failsafe program
(powertrain control module, also called an ECM). That consists of a few different components but the P0021 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is above a set limit (over-advanced), the engine light will be illluminated and the code will be set. The "A" camshaft is either the intake, left, or front camshaft. A P0021 engine code is basically the same as a P0011 code, except this is for Bank 2, not Bank 1.
Symptoms
Possible sumptoms of OBD code P0021
Most likely a P0021 DTC will result in one of the following: hard starting, poor idle, and/or stalling. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.
Causes
Possible causes of OBD code P0021
A P0021 DTC trouble code may be caused by one or more of the following:
Possible Solutions
This DTC code is a result of a mechanical fault of the VCT unit or related components, so there is no need for electrical diagnosis. Refer to vehicle specific repair manual to perform component tests for the VCT unit. Notes: Dealer techs have advanced tools and the ability to follow detailed troubleshooting steps, including the ability to test components using a scan tool.
I was driving my car suddenly it powered off and it will not restart. I had the battery tested, its fine.
Hi Cindy, sorry to hear about your problems., the fault could be any of a number of things. The first thing I would do is check that the timing belt is intact and on the vehicle, this would be the first step. I would not crank the car over to attempt to start it because, if the timing belt has snapped you could be causing damage that is very expensive to fix.
If the timing belt is okay I woild check whether the fuel and the spark happen at the same time in the combustion chamber.The fuel obviously has to be squirted into the engine just before the spark is made to explode it in order to make the engine work. If the fuel does not go in just at the right time and the spark does not explode it at just the right time the car will not run. Either you, or your mechanic needs to establish how this process is going wrong.
Do not let just anybody check your car over, get recommendations from experienced drivers for a good mechanic to help you sort this problem out.
GOOD LUCK
How to fix p0021 of range rover 2008 model
Your fault code I think is a cam shaft sensor fault Depending on what engine u got it could be the sensor wiring or the timing is out . If u got a v engine u should have p0011 as well that would prob be timing out hope it has helped
How do i fix p0002 of land rover 2008 model
faulty sensors
Generally related to fuel supply system system
Possible Solutions
The P0002 is an OBDII generic code, but almost none of the vehicle manufactures use it. If you are getting this code, make sure you are using the correct OBDII code scanner for your vehicle's make and model. Check Fuel Supply with pressure meter Ensure the fuel pump is working (Check fuses and power at pump) Check that fuel return line is working
Trouble Code:
System:
Subsystem:
P0002 - (
ASE)
Powertrain
Fuel & Air metering, Auxiliary emission controls
DTC Description: Fuel Volume Regulator Control Circuit Range / Performance
Location:
Analysis:
Likely Cause:
Out of Expected Range
My land rover will not come out of park.
Land-Rover Lost Communication With Parking Assist Control Mod.
You need someone with a tech 2 or a landrover specific diagnostic unit there are no work rounds that i know of sorry doctor needed.
Land rover alarm and car horn
your remote is picking up another signal some place and your cars being haunted by itreset alarm settings now the other problem is your battery is getting weak loosing its charge because its constantly on simple get charger to trickel charge system or replace battery
My 2008 Range Rover Vogue TDV8 keeps draining the
The Range Rover runs system even when you have locked the car and walked away, you can often here the fan on the computer running from inside the front wheel arch. What can happen is if there is an error caused by a faulty sensor then the computer fails to shot down and instead runs all night until the battery goes flat. Best thing is to get fault codes read and start to try and figure out what exactly is causing it to happen. I would say that this is a common problem but most people don't realise why its happened as they only realise when the car has gone flat.
Not finding what you are looking for?