20 Most Recent
2008 Isuzu I 290 Questions & Answers
I had owned a 08
they might be saying rusty fuel tank
water in the fuel tank or bad fuel
you could replace the fuel tank with a used one
then replacing the fuel pump should fix the problem
Tpm reset 2008 isuzu i290
it resets every time you key on.
the Tire pressure monitoring system. TPMS.
on good cars, the system tells you exactly what is wrong.(dash)
EG, my jeep shows, R/F tire bad. so replace that sensor
or if tad older car,? i must use my scan tool to see which sensor is failing, on mine even the spare must work.....
so if no scan tool and a "intellectually challenged")ECU.(PCM) per above....
then what to do, tool-less? (no scanner tool for pcm no scan for TPMS)
you go to any tire shop in town, and say, scan my tires.
we have this scanner and wave it over the stems.
omg one is dead.
or one reads wrong fibs.
or other errors.... (over temp, serial wrong, etc)
it's just a battery powered sensor. on each rim stem.
that be about it....
Touble codes po506d p1400 on my 2007 izusu i290 what do they mean
the first one is wrong, wrote down wrong.
P0506 is idle speed too low. (vast causes.)
1400
Cold Start Emission Reduction Control System
1400s are caused by 506s. so 506s is it.
id not take a kid toy to zoned, but what eva.
they mean what the FSM says they mean,, factory serv. manual
did you even try to google them/?
so why is engine idle too low.
- Gross misire.
- too lean or too rich fuel mix.
- ISC stuck closed.
- EGR valve stuck open,.
- bad spark plugs ,ever consider doing a full 60k mile tune up?
- air leaks to the induction on MAF based engines,
- low compression on one or more cylinders.
- i can list 41 more. but why? we just do the test , quickly and cause is found.
the real scan tool can monitor many live engine parameters.
and see if all is working good. we do that, first.
eg: are all sensors reading right?
SERV TPM LIGHT IS ON AFTER CHANGING TIRES
That Must be a Sensor on The Disc Brake Pads Are They Not Worn Out If Not Its Touching Earth Somewhere , It Should Be a Single Wire With A Bullet Connector At The Brake Caliper
Low beam headlight is out on 2008 i290
Hi
Most probably you are seeing a lot of clutter in the bonnet to put your hand in and change it right? The best way sometimes is to unbolt the headlamp , move it out change the bulb and back in. But another way would typically be to remove the battery (and battery holder plastic box) or air box (whichever is in the way) and then you should be able to access the headlamp cover from behind. Anyways in both cases you should find a metal clip holding the bulb. Unclip the bulb whilst making sure that you dont touch the new bulb with you hands while putting it in. Press its metal clip in place again. and be sure to mount the plastic cover at the back properly so no water goes in the headlamp if its raining.
It was nice to help you :)
Best Regards
Check engine light
scan first your vehicle for fault codes and identify what caused the MIL to come on. Some codes after correcting might disappear after a few start. Others need to be reset. disconnect battery cable for at least 10 seconds to a minute then reconnect to erase codes. Other codes that involves safety will not be removed until corrected.
Not finding what you are looking for?