20 Most Recent
- Page 3 Questions & Answers
How can I install an 8000 lb 5.5 hp winch and install front to back wiring rated for at least 360 amps?
There must be endless info about this online or youtube or any of the offroad sites.
Make sure you mount a good cut out switch between the battery and winch you can access in a hurry to save your truck. A big fuse is usually available from the winch co rated for that winch. If it all goes wrong you can isolate the winch. Cable is going to be stick welding cable size to get good power. Be careful how you route it. Its a big winch, use a professional mounting kit and good quality fasteners.
on Feb 17, 2016
Where is the fuse located for the daytime running lights on a 2005 Chev Siveraado?
It is located in the underhood fuse/relay box , marked DRL 10 amp fuse ! Also if that is good check the DRL relay in the same fuse/relay box .Your light sensor could also be bad .
The daytime running lamps (DRL) will operate when the ignition switch is in the RUN position, for automatic transmissions (A/T), the gear selector is not in the PARK position, the headlamp switch is in the AUTO position, and for manual transmissions (M/T), the park brake is released. When these conditions have been met and the ambient light sensor indicates daytime conditions, the DRL will illuminate. The ambient light sensor is a light sensitive transistor that varies its voltage signal to the body control module (BCM) in response to changes to the outside (ambient) light level. When the BCM receives this signal it will either turn on the DRL or the headlamps for auto headlamp operation. Any function or condition that turns on the headlights will cancel the daytime running lamps operation. The DRL can be manually turned OFF by depressing the AHL/DRL switch in the headlamp switch
Do you know that on inside of fuse box lid it shows what fuse is what .
on Feb 01, 2016
Not finding what you are looking for?