20 Most Recent 2000 BMW 7 Series Questions & Answers

have you put a different type of power steering fluid?

in some instance, if they put a different type of fluid, the solution bubbles up and makes a whining noise when you use the car.

tnx 4 using fixya,

drcool

you need a monitor upgrade

Here are some suggestions... For fault 140 thermostat you may also want to check thermostat wiring connector by t-stat and also DME (disconnect inspect clean) For fault 185 leakage... try this; The wiring to the Fuel tank leak pump chafes on the L/R inner fender liner and cuts the wire in half or opens the insulation and the wire corrodes. Pull the L/R wheel and then remove the fender liner. You will probably see a spot on the liner where the wire has rubbed. Find the break in the wire and fix it. Reroute the wire so it does not chafe again. For fault 106 replace the brake light switch under the dash

Could leak on the seal?

Go to auto zone they check for free, then will know what's is next.

run the fault codes and check for problem air temp sensor , MAF/VAF sensors

Hi there, Page 104 of the user manual articulates the climate controls functions of the vehicle. Defrosters are identified as buttons 16 (front) and 15 (rear). Temperature control with buttons (6) down and 8 (up). All Docs BMW 7 Series Owner Manuals

This is normally a problem with the LCD display and cannot be fixed. Im sorry but you will have to try and locate a used unit from an auto breaker or buy a new one.

check the negative wire from the battery to the body (not good ground ) clean

okay so what's the problem no power no what. have to be a little more detailed with your problems

Neutral lockout switch or ignition switch if the car is an automatic. Switch on the clutch if it is a stick. If auto try starting it in neutral.

change your bulbs.

You need to get the code from the dealer.