20 Most Recent 1996 Mazda MX-5 Miata Questions & Answers

Pel, the 80 amp main is bolted into the fuse block. Disconnect battery, metric 10 socket removes the block by the 2 bolts on the engine side, same size bolts on both side of the block, remove them both have ring connectors, be sure to reconnect them when putting back together. I did this same thing last monday during a hail and rain storm.

replace the fuse box as the fuse is welded in place

Hi there Not normal at all. Could be a connection problem at the air bag pre tensioners, the part where your seat belt clips in to when you wearing the seat belt, or could be the hooter ring contact that is not good or the airbag/s has been activated then airbag computer and seatbelt stalks that activated has to be replaced. Hope this sheds some light. Regards Phillip

try either 1414 or 0532. on my mx5 2003 UK its 1414

If not obvious, slightly loosen supply line. Remember, air rises, so bleed at master also.

The above is a good explanation of accessing the mirror but to answer your question directly, yes, they will fit. All the 90-97 mirrors are interchangeable with the exception of installing later power mirrors onto a 90-91 Miata where it wasn't a factory option. They will mount up fine but do require enlarging the center hole where the wires need to run.

Maybe you can find it with the wiring diagram. http://www.mellens.net/mazda/mazda_miata_extra_manual/1996_wiring.pdf

It may have broke the plastic clip on the actuation motor arm, or it has came off track. There could be other factors causing problems. One of those things you really don't know for sure until you take it apart to find the actual problem. Auto body repair shops are good at fixing window motor issues.

12,13,14,or 15 MM. Been a long time. Most likely the 14MM.

check bulbs If you need further help, I’m available over the phone at https://www.6ya.com/expert/mike_9693b5ad75773352

if this is a petrol engine check that the "o" rings under the injectors are correctly installed.. If a diesel check that the diesel lines are tight

The TCM is the Transmission Control Module.

Don't use it Find the leak & repair it Can't guess at the unknown from the internet --- can we?

The E mark on the left camshaft pulley should line up with the E mark on the camshaft cover. The I mark on the right camshaft pulley should line up with the I mark on the head. There is also a notch on the top of the bottom pulley that needs to line up with the cast pointer above this pulley. I like to mark stuff when I am taking it apart with white paint, it is easy to see when putting stuff back together. The www.miata.net/garage has some help on this.