20 Most Recent
1996 Mazda MX-5 Miata - Page 3 Questions & Answers
My mx5 n reg 1.6 is making like a pulling when
Start from easyest -
1. Check spark plugs and distributor for wear and aging
2. Check air filter
3. Check exhaust for any obstructions
4. Check fuel filter.(if petrol is dark - then you should change the filter)
I have a 1996 Miata
Hello
The clutch in this car is hydraulic, and most likely have failed. The symptom is the clutch pedal goes to the floor and has no resistance, did this happen or do you something else? Please describe exactly what is going on with the clutch, not that is just doesn't work, but what exactly the physical symptoms are. Also if the clutch slave moves the rod that disengages the clutch pressure plate, the clutch hydraulic slave is on the outside of the bell housing get under and look at it while someone presses the clutch down. See picture below.
Hi, I have 96 mazda
The lighter itself could have gone bad. The actual cigarette lighter part go bad if they are used frequently. The socket part are less likely to bad but they do on occasion. If you have a car charger for your cell phone or something of that nature you can find out if its the receptical or the lighter itself.
Fault code p1794
The correct eplanation for DTC P1794 is:
Powertrain Control Module Battery Direct Power Circuit
Umm my car wants to
check fuses for broken ones using a fuse tester or by pulling them one by one and lookin at the conductor inside to see if burnt or discontinuous.
Alternator went out and killed the battery.
I cannot access the wiring diagram, but one of the wires from the alternator usually goes to the dash light. It may go through the computer or other circuitry on the way. If you can trace that wire, you may find the problem. Sorry I can't tell you more without the diagram.
Where is the intirior fuse
On the drivers side of the car. Look behind the hood release and you should see a little black cover explaining which fuse is what.
I have a 1996 Mazda Miata and the drivers side
remove the inner door cover, somtime's u need a spetial too to remove the handle befor this cane be doen, next check the track for ubsrutios and make shure the windon is stright in the track's
Where do i put power steering fluid in an mx5
Next to your front left light you will find a small plastic filling rod like an oil check rod but totally black. You just have to unscrew it slightly and you can check the Low or Full (L and F indicators) level of your PSO.
Coming to what to put in it. Mk1's accept both ATF oil (Automatic Transmission Fluid - Red colour) and Power steering Fluid (PSF - Green colour). Mixing them is also no specific issue but not recommended.
Please check the hose under the recipient you fill in as it can often be cracked after winter periods.
Cheers
François
Washed car...lift hood to wash leaves...car
Yeah, you sound like you have water down in the plug/wires. You will need to dry out the wires from the plugs to the coil pack. You can buy a solution spray to dry these out faster than air dry. But it will have to be dried before it runs good.
Is there any product that stops the squeak of my
autozone sells some stuff called belt dressing that will take care of squeling belts. but make sure its a belt at fault,and not pully sticking on a part,for example power steering pump,altenator ,water pump etc...
Manual window winder just spinning and not opening
You either need a new window crank itself, the inside of the crank could be stripped, you move the crank and out at it to see if the splines are wore away. Or your window regulator, inside the door, has gone bad and would need replaced.
Not finding what you are looking for?